STM32W108CC STMicroelectronics, STM32W108CC Datasheet - Page 60

• Manufacturer Part Number: STM32W108CC
• Description: High-performance, IEEE 802.15.4 wireless system-on-chip with embedded Flash memory
• Manufacturer: STMicroelectronics

Specifications of STM32W108CC

• Receive Current (w/ Cpu): 27 mA
• Transmit Current (w/ Cpu, +3 Dbm Tx): 31 mA
• Low Deep Sleep Current, With Retained Ram And Gpio: 400 nA/800 nA with/without sleep timer
• Standard Arm Debug Capabilities: Flash patch & breakpoint; data watchpoint & trace; instrumentation trace macrocell
• Single Voltage Operation: 2.1-3.6 V with internal 1.8 V and 1.25 V regulators

General-purpose input/outputs
8.1.3
Note:
60/232
Table 22.
If a GPIO has two peripherals that can be the source of alternate output mode data, then
other registers in addition to GPIO_PxCFGH/L determine which peripheral controls the
output.
Several GPIOs share an alternate output with Timer 2 and the Serial Controllers. Bits in
Timer 2's TIM2_OR register control routing Timer 2 outputs to different GPIOs. Bits in Timer
2's TIM2_CCER register enable Timer 2 outputs. When Timer 2 outputs are enabled they
override Serial Controller outputs.
depending on the bits in the register TIM2_OR. Refer to
on page 115
Table 23.
For outputs assigned to the serial controllers, the serial interface mode registers
(SCx_MODE) determine how the GPIO pins are used.
The alternate outputs of PA4 and PA5 can either provide packet trace data (PTI_EN and
PTI_DATA), or synchronous CPU trace data (TRACEDATA2 and TRACEDATA3).
If a GPIO does not have an associated peripheral in alternate output mode, its output is set
to 0.
Forced functions
For some GPIOs the GPIO_PxCFGH/L configuration may be overridden.
the GPIOs that can have different functions forced on them regardless of the
GPIO_PxCFGH/L registers.
The DEBUG_DIS bit in the GPIO_DBGCFG register can disable the Serial Wire/JTAG
debugger interface. When this bit is set, all debugger-related pins (PC0, PC2, PC3, PC4)
behave as standard GPIO.
Alternate Output (open-
drain)
Alternate Output (push-pull)
SPI SCLK Mode
Timer 2 output
TIM2_CH1
TIM2_CH2
TIM2_CH3
TIM2_CH4
GPIO mode
GPIO configuration modes (continued)
Timer 2 output configuration controls
for complete information on timer configuration.
STM32W108HB STM32W108CC STM32W108CB STM32W108CZ
Option register bit
GPIO_PxCFGH/L
0xD
0xB
TIM2_OR[4]
TIM2_OR[5]
TIM2_OR[6]
TIM2_OR[7]
Doc ID 16252 Rev 13
Table 23
indicates the GPIO mapping for Timer 2 outputs
Open-drain output. An onboard peripheral controls
the output. If a pull up is required, it must be
external.
Push-pull output mode only for SPI master mode
SCLK pins.
GPIO mapping selected by TIM2_OR bit
Section 10: General-purpose timers
PA0
PA3
PA1
PA2
0
Description
Table 24
PB1
PB2
PB3
PB4
1
shows