ST72561R9-Auto STMicroelectronics, ST72561R9-Auto Datasheet - Page 285

• Manufacturer Part Number: ST72561R9-Auto
• Description: 8-bit MCU for automotive
• Manufacturer: STMicroelectronics

Specifications of ST72561R9-Auto

• Hdflash Endurance: 100 cycles, data retention 20 years at 55 °C
• 5 Power Saving Modes: halt, auto wake up from halt, active halt, wait and slow

ST72561-Auto
depends on the number of supply pins in the device (3 parts*(n+1) supply pin). Two models
can be simulated: human body model and machine model. This test conforms to the
JESD22-A114A/A115A standard.
Static and dynamic latch-up
●
●
Table 111. Absolute maximum ratings
1. Data based on characterization results, not tested in production.
Table 112. Electrical sensitivities
1. Class description: A Class is an STMicroelectronics internal specification. All its limits are higher than the
V
V
V
Symbol
ESD(CDM)
Symbol
ESD(HBM)
ESD(MM)
JEDEC specifications, that means when a device belongs to Class A it exceeds the JEDEC standard. B
Class strictly covers all the JEDEC criteria (international standard).
DLU
LU
LU: three complementary static tests are required on 10 parts to assess the latch-up
performance. A supply overvoltage (applied to each power supply pin) and a current
injection (applied to each input, output and configurable I/O pin) are performed on each
sample. This test conforms to the EIA/JESD 78 IC latch-up standard. For more details,
refer to application note AN1181.
DLU: electrostatic discharges (one positive then one negative test) are applied to each
pin of three samples when the micro is running to assess the latch-up performance in
dynamic mode. Power supplies are set to the typical values, the oscillator is connected
as near as possible to the pins of the micro and the component is put in reset mode.
This test conforms to the IEC1000-4-2 and SAEJ1752/3 standards. For more details,
refer to application note AN1181.
Electrostatic discharge voltage (human
body model)
Electrostatic discharge voltage (machine
model)
Electro-tatic discharge voltage (charge
device model)
Static latch-up class
Dynamic latch-up class
Parameter
Ratings
Doc ID 12370 Rev 8
T
T
T
V
A
A
A
DD
= +25°C
= +85°C
= +125°C
= 5.5V, f
OSC
Conditions
T
Conditions
A
= +25°C
= 4 MHz, T
A
Electrical characteristics
750 on corner pins,
Maximum value
= +25°C
500 on others
2000
200
Class
(1)
A
285/324
(1)
Unit
V