ST72521R9 STMicroelectronics, ST72521R9 Datasheet - Page 54

• Manufacturer Part Number: ST72521R9
• Description: 8-BIT MCU WITH NESTED INTERRUPTS, FLASH, 10-BIT ADC, FIVE TIMERS, SPI, SCI, I2C, CAN INTERFACE
• Manufacturer: STMicroelectronics

Specifications of ST72521R9

• Hdflash Endurance: 100 cycles, data retention
• Clock Sources: crystal/ceramic resonator oscillators, internal RC oscillator and bypass for external clock
• Four Power Saving Modes: Halt, Active-Halt, Wait and Slow
• Main Clock Controller With: Real time base, Beep and Clock-out capabilities
• Two 16-bit Timers With: 2 input captures, 2 output compares, external clock input on one timer, PWM and pulse generator modes
• 8-bit Pwm Auto-reload Timer With: 2 input captures, 4 PWM outputs, output compare and time base interrupt, external clock with event detector

ST72F521, ST72521B
WATCHDOG TIMER (Cont’d)
10.1.4 How to Program the Watchdog Timeout
Figure 33
the 6-bit value to be loaded in the Watchdog Coun-
ter (CNT) and the resulting timeout duration in mil-
liseconds. This can be used for a quick calculation
without taking the timing variations into account. If
Figure 33. Approximate Timeout Duration
54/215
3F
38
30
28
20
18
10
08
00
1.5
shows the linear relationship between
18
34
Watchdog timeout (ms) @ 8 MHz. f
50
more precision is needed, use the formulae in
ure
Caution: When writing to the WDGCR register, al-
ways write 1 in the T6 bit to avoid generating an
immediate reset.
65
34.
82
OSC2
98
114
128
Fig-