HT56R66 Holtek Semiconductor Inc., HT56R66 Datasheet - Page 74

• Manufacturer Part Number: HT56R66
• Description: Tinypower Tm A/d Type With Lcd 8-bit Otp Mcu
• Manufacturer: Holtek Semiconductor Inc.

Another reset exists in the form of a Low Voltage Reset,
LVR, where a full reset, similar to the RES reset is imple-
mented in situations where the power supply voltage
falls below a certain threshold.
Reset Functions
There are five ways in which a microcontroller reset can
occur, through events occurring both internally and ex-
ternally:
Rev. 1.10
Power-on Reset
The most fundamental and unavoidable reset is the
one that occurs after power is first applied to the
microcontroller. As well as ensuring that the Program
Memory begins execution from the first memory ad-
dress, a power-on reset also ensures that certain
other registers are preset to known conditions. All the
I/O port and port control registers will power up in a
high condition ensuring that all pins will be first set to
inputs.
Although the microcontroller has an internal RC reset
function, if the VDD power supply rise time is not fast
enough or does not stabilise quickly at power-on, the
internal reset function may be incapable of providing
proper reset operation. For this reason it is recom-
mended that an external RC network is connected to
the RES pin, whose additional time delay will ensure
that the RES pin remains low for an extended period
to allow the power supply to stabilise. During this time
delay, normal operation of the microcontroller will be
inhibited. After the RES line reaches a certain voltage
value, the reset delay time t
an extra delay time after which the microcontroller will
begin normal operation. The abbreviation SST in the
figures stands for System Start-up Timer.
For most applications a resistor connected between
VDD and the RES pin and a capacitor connected be-
tween VSS and the RES pin will provide a suitable ex-
ternal reset circuit. Any wiring connected to the RES
pin should be kept as short as possible to minimise
any stray noise interference.
For applications that operate within an environment
where more noise is present the Reset Circuit shown
is recommended.
More information regarding external reset circuits is
located in Application Note HA0075E on the Holtek
website.
Power-On Reset Timing Chart
RSTD
is invoked to provide
74
Note:
RES Pin Reset
This type of reset occurs when the microcontroller is
already running and the RES pin is forcefully pulled
low by external hardware such as an external switch.
In this case as in the case of other reset, the Program
Counter will reset to zero and program execution initi-
ated from this point.
Low Voltage Reset
The microcontroller contains a low voltage reset circuit
in order to monitor the supply voltage of the device,
which is selected via a configuration option. If the supply
voltage of the device drops to within a range of
0.9V~V
tery, the LVR will automatically reset the device inter-
nally. The LVR includes the following specifications: For
a valid LVR signal, a low voltage, i.e., a voltage in the
range between 0.9V~V
value t
voltage state does not exceed 1ms, the LVR will ignore it
and will not perform a reset function. One of a range of
specified voltage values for V
configuration options. The V
a pair in conjunction with a Low Voltage Detect value.
added for added ESD protection
added in environments where power line noise
is significant
LVR
* It is recommended that this component is
** It is recommended that this component is
LVR
Low Voltage Reset Timing Chart
specified in the A.C. characteristics. If the low
such as might occur when changing the bat-
RES Reset Timing Chart
External RES Circuit
HT56R66/HT56R666
LVR
LVR
must exist for greater than the
LVR
LVR
value will be selected as
can be selected using
September 8, 2009