FMA80N10T2 Fuji Electric holdings CO.,Ltd, FMA80N10T2 Datasheet - Page 10

Manufacturer Part Number

FMA80N10T2

Description

N-channel Enhancement Mode Power Mosfet

Manufacturer

Fuji Electric holdings CO.,Ltd

Datasheet

1.FMA80N10T2.pdf (19 pages)

･ The immersion depth of the lead should basically be up to the lead stopper and the distance should

･ When flow-soldering, be careful to avoid immersing the package in the solder bath.

Fuji Electric Device Technology Co.,Ltd.

Recommended soldering condition

･ Before touching a MOSFET terminal, Discharge any static electricity from your body and clothes

･ When soldering, in order to protect the MOSFETs from static electricity, ground the soldering iron

･ You must design the MOSFETs to be operated within the specified maximum ratings(voltage,

･ Consider the possible temperature rise not only for the channel and case, but also for the outer

･ Do not directly touch the leads or package of the MOSFETs while power is supplied or during

･ The MOSFETs are made of incombustible material. However, if a MOSFET fails, it may emit

･ The MOSFETs should not used in an environment in the presence of acid, organic matter, or

･ The MOSFETs should not used in an irradiated environment since they are not radiation-proof.

Installation

･ Soldering involves temperatures which exceed the device storage temperature rating. To avoid

be a maximum of 1.5mm from the device.

by grounding out through a high impedance resistor (about 1M )

or soldering bath through a low impedance resistor.

current, temperature, etc.) to prevent possible failure or destruction of devices.

leads.

operation in order to avoid electric shock and burns.

smoke or flame. Also, operating the MOSFETs near any flammable place or material may cause

the MOSFETs to emit smoke or flame in case the MOSFETs become even hotter during

operation. Design the arrangement to prevent the spread of fire.

corrosive gas(hydrogen sulfide, sulfurous acid gas etc.)

device damage and to ensure reliability, observe the following guidelines from the quality

assurance standard.

Through-Hole