st62t65cm3 STMicroelectronics, st62t65cm3 Datasheet - Page 21

• Manufacturer Part Number: st62t65cm3
• Description: 8-bit Otp/eprom Mcus With A/d Converter, Safe Reset, Auto-reload Timer, Eeprom And Spi
• Manufacturer: STMicroelectronics

CLOCK SYSTEM (Cont’d)
Oscillator Control Registers
Address: DCh — Write only
Reset State: 00h
Bit 7-4. These bits are not used.
Bit 3. Reserved. Cleared at Reset. Must be kept
cleared.
Bit 2. Reserved. Must be kept low.
RS1-RS0. These bits select the division ratio of
the Oscillator Divider in order to generate the inter-
nal frequency. The following selctions are availa-
ble:
7
-
-
-
-
OSCR
3
-
RS1
RS0
0
Note: Care is required when handling the OSCR
register as some bits are write only. For this rea-
son, it is not allowed to change the OSCR contents
while executing interrupt service routine, as the
service routine cannot save and then restore its
previous content. If it is impossible to avoid the
writing of this register in interrupt service routine,
an image of this register must be saved in a RAM
location, and each time the program writes to
OSCR it must write also to the image register. The
image register must be written first, so if an inter-
rupt occurs between the two instructions the
OSCR is not affected.
RS1
0
0
1
1
ST62T55C ST62T65C/E65C
RS0
0
1
0
1
Division Ratio
1
2
4
4
21/86