isp1504a1 NXP Semiconductors, isp1504a1 Datasheet - Page 29

• Manufacturer Part Number: isp1504a1
• Description: Isp1504a1; Isp1504c1 Ulpi Hi-speed Universal Serial Bus On-the-go Transceiver
• Manufacturer: NXP Semiconductors

NXP Semiconductors
ISP1504A1_ISP1504C1_1
Product data sheet
9.5.2.3 Using and selecting the V
The V
link whenever there is a change in the V
must first enable corresponding interrupts in the USB Interrupt Enable Rising Edge and
USB Interrupt Enable Falling Edge registers.
The link can use the V
shows the recommended usage for typical applications.
Table 15.
Standard USB Host Controllers:
500 mA on V
detect overcurrent conditions. If the external overcurrent detector provides a digital fault
signal, then the fault signal must be connected to the ISP1504x1 FAULT input pin, and the
link must do the following:
Standard USB Peripheral Controllers:
when V
start and end of USB peripheral operations. Detection of A_VBUS_VLD and SESS_END
thresholds is not needed for standard peripherals.
Application
Standard host
Standard peripheral no
OTG A-device
OTG B-device
1. Set the IND_COMPL bit in the Interface Control register to logic 0 or logic 1,
2. Set the USE_EXT_VBUS_IND bit in the OTG Control register to logic 1.
3. If it is not necessary to qualify the fault indicator with the internal A_VBUS_VLD
Fig 10. RXCMD A_VBUS_VLD indicator source
USE_EXT_VBUS_IND,
depending on the polarity of the external fault signal.
comparator, set the IND_PASSTHRU bit in the Interface Control register to logic 1.
BUS
IND_PASSTHRU
BUS
state encoding is shown in
IND_COMPL
V
is at a sufficient level for operation. SESS_VLD must be enabled to detect the
BUS
BUS
FAULT
V
indicators in RXCMD required for typical applications
BUS
in the range of 4.75 V to 5.25 V. An external circuit must be used to
A_VBUS_VLD comparator
A_VBUS_VLD
yes
yes
no
FAULT indicator
BUS
Rev. 01 — 6 August 2007
state to monitor V
BUS
state encoding
internal A_VBUS_VLD
For standard hosts, the system must be able to provide
Table
BUS
ISP1504A1; ISP1504C1
SESS_VLD
no
yes
yes
yes
Standard peripherals must be able to detect
11. The ISP1504x1 will send an RXCMD to the
state. To receive V
BUS
complement
and take appropriate action.
output
ULPI HS USB OTG transceiver
SESS_END
no
no
no
yes
BUS
state updates, the link
004aaa698
(0, X)
(1, 0)
(1, 1)
© NXP B.V. 2007. All rights reserved.
RXCMD
A_VBUS_VLD
Table 15
29 of 80