c8051t602 Silicon Laboratories, c8051t602 Datasheet - Page 13

• Manufacturer Part Number: c8051t602
• Description: Mixed Signal Otp Eprom Mcu Family
• Manufacturer: Silicon Laboratories

1.
C8051T600/1/2/3/4/5 devices are fully integrated mixed-signal System-on-a-Chip MCUs. Highlighted fea-
tures are listed below. Refer to Table 1.1 on page 14 for specific product feature selection.
•
•
•
•
•
•
•
•
•
•
•
•
•
With on-chip Power-On Reset, Supply Monitor, Watchdog Timer, and clock oscillator, the C8051T600/1/2/
3/4/5 devices are truly stand-alone System-on-a-Chip solutions. User software has complete control of all
peripherals, and may individually shut down any or all peripherals for power savings.
Code written for the C8051T600/1/2/3/4/5 family of processors will run on the C8051F300 Mixed-signal
ISP Flash microcontroller, providing a quick, cost-effective way to develop code without requiring special
emulator circuitry. The C8051T600/1/2/3/4/5 processors include Silicon Laboratories’ 2-Wire C2 Debug
and Programming interface, which allows non-intrusive (uses no on-chip resources), full speed, in-circuit
debugging using the production MCU installed in the final application. This debug logic supports inspection
of memory, viewing and modification of special function registers, setting breakpoints, single stepping, run
and halt commands. All analog and digital peripherals are fully functional while debugging using C2. The
two C2 interface pins can be shared with user functions, allowing in-system debugging without occupying
package pins.
Each device is specified for 1.8-to-3.6 V operation over the industrial temperature range (–45 to +85 °C).
An internal LDO is used to supply the processor core voltage at 1.8 V. The Port I/O and RST pins are toler-
ant of input signals up to 5 V. The C8051T600/1/2/3/4/5 are available in 3 x 3 mm 11-pin QFN or 14-pin
SOIC packaging.
High-speed pipelined 8051-compatible microcontroller core (up to 25 MIPS)
In-system, full-speed, non-intrusive debug interface
C8051F300 ISP Flash device is available for quick in-system code development
10-bit 500 ksps ADC with programmable analog multiplexer and integrated temperature sensor
Precision calibrated 24.5 MHz internal oscillator
2/4/8 kB of on-chip One-Time Programmable (OTP) EPROM
256 bytes of on-chip RAM
SMBus/I
Three general-purpose 16-bit timers
Programmable Counter/Timer Array (PCA) with three capture/compare modules and Watchdog Timer
function
On-chip Power-On Reset and Supply Monitor
On-chip Voltage Comparator
Byte-wide I/O Port (5 V tolerant)
System Overview
2
C and Enhanced UART serial interfaces implemented in hardware
Rev. 0.5
C8051T600/1/2/3/4/5
13