mc9s12e256 Freescale Semiconductor, Inc, mc9s12e256 Datasheet - Page 105

• Manufacturer Part Number: mc9s12e256
• Description: Hcs12 Microcontrollers 16-bit Microcontroller
• Manufacturer: Freescale Semiconductor, Inc

Except for the sector erase abort command, a buffered command will wait for the active operation to be
completed before being launched. The sector erase abort command is launched when the CBEIF flag is
cleared as part of a sector erase abort command write sequence. After a command is launched, the
completion of the command operation is indicated by the setting of the CCIF flag. The CCIF flag only sets
when all active and buffered commands have been completed.
2.4.1.3
Table 2-20
block.
Freescale Semiconductor
FCMDB
0x05
0x06
0x20
0x40
0x41
0x47
Erase Verify Verify all memory bytes in the Flash block are erased. If the Flash block is erased, the BLANK flag in
Mass Erase Erase all memory bytes in the Flash block. A mass erase of the full Flash block is only possible when
Erase Abort
Command
Compress
summarizes the valid Flash commands along with the effects of the commands on the Flash
Program
Sector
Sector
Erase
NVM
Data
Valid Flash Commands
A Flash word must be in the erased state before being programmed.
Cumulative programming of bits within a Flash word is not allowed.
the FSTAT register will set upon command completion.
Compress data from a selected portion of the Flash block. The resulting signature is stored in the
FDATA register.
Program a word (two bytes) in the Flash block.
Erase all memory bytes in a sector of the Flash block.
FPLDIS, FPHDIS, and FPOPEN bits in the FPROT register are set prior to launching the command.
Abort the sector erase operation. The sector erase operation will terminate according to a set
procedure. The Flash sector must not be considered erased if the ACCERR flag is set upon command
completion.
Table 2-20. Valid Flash Command Description
MC9S12E256 Data Sheet, Rev. 1.08
CAUTION
Function on Flash Memory
Chapter 2 256 Kbyte Flash Module (FTS256K2V1)
105