X9312WPI INTERSIL [Intersil Corporation], X9312WPI Datasheet - Page 3

• Manufacturer Part Number: X9312WPI
• Description: Terminal Voltage 0V to + 15V, 100 Taps
• Manufacturer: INTERSIL [Intersil Corporation]

INSTRUCTIONS AND PROGRAMMING
The INC, U/D and CS inputs control the movement of
the wiper along the resistor array. With CS set LOW
the device is selected and enabled to respond to the
U/D and INC inputs. HIGH to LOW transitions on INC
will increment or decrement (depending on the state of
the U/D input) a seven bit counter. The output of this
counter is decoded to select one of one hundred wiper
positions along the resistive array.
The value of the counter is stored in nonvolatile
memory whenever CS transitions HIGH while the INC
input is also HIGH.
The system may select the X9312, move the wiper
and deselect the device without having to store the
latest wiper position in nonvolatile memory. After the
wiper movement is performed as described above and
once the new position is reached, the system must
keep INC LOW while taking CS HIGH. The new wiper
position will be maintained until changed by the
system or until a powerup/down cycle recalled the
previously stored data.
This procedure allows the system to always power-up
to a preset value stored in nonvolatile memory; then
during system operation minor adjustments could be
made. The adjustments might be based on user
preference, system parameter changes due to
temperature drift, etc...
The state of U/D may be changed while CS remains
LOW. This allows the host system to enable the
device and then move the wiper up and down until the
proper trim is attained.
3
X9312
MODE SELECTION
SYMBOL TABLE
CS
H
L
L
WAVEFORM
INC
H
X
L
U/D
H
X
X
X
L
INPUTS
Must be
steady
May change
from Low to
High
May change
from High to
Low
Don’t Care:
Changes
Allowed
N/A
Wiper up
Wiper down
Store wiper position
Standby current
No store, return to standby
OUTPUTS
Will be
steady
Will change
from Low to
High
Will change
from High to
Low
Changing:
State Not
Known
Center Line
is High
Impedance
Mode
March 15, 2005
FN8176.0