ICE3BR1065J_11 INFINEON [Infineon Technologies AG], ICE3BR1065J_11 Datasheet - Page 29

• Manufacturer Part Number: ICE3BR1065J_11
• Manufacturer: INFINEON [Infineon Technologies AG]

9
Figure 35
General guideline for PCB layout design using F3/F3R CoolSET
1. “Star Ground “at bulk capacitor ground, C11:
Guideline for PCB layout design when >3KV lightning surge test applied (refer to Figure 35):
1. Add spark gap
Version 2.0
2. High voltage traces clearance:
3. Filter capacitor close to the controller ground:
a. Spark Gap 3 and Spark Gap 4, input common mode choke, L1:
a. 400V traces (positive rail of bulk capacitor C11) to nearby trace: > 2.0mm
b. 600V traces (drain voltage of CoolSET
a. DC ground of the primary auxiliary winding in power transformer, TR1, and ground of C16 and Z11.
b. DC ground of the current sense resistor, R12
c. DC ground of the CoolSET
d. DC ground from bridge rectifier, BR1
e. DC ground from the bridging Y-capacitor, C4
High voltage traces should keep enough spacing to the nearby traces. Otherwise, arcing would incur.
Spark gap is a pair of saw-tooth like copper plate facing each other which can discharge the accumulated
Gap separation is around 1.5mm (no safety concern)
charge during surge test through the sharp point of the saw-tooth plate.
Filter capacitors, C13, C14 and C15 should be placed as close to the controller ground and the controller pin
as possible so as to reduce the switching noise coupled into the controller.
separately in one point. It can reduce the switching noise going into the sensitive pins of the CoolSET
effectively. The primary DC grounds include the followings.
“Star Ground “means all primary DC grounds should be connected to the ground of bulk capacitor C11
of IC12 should be connected to the GND pin of IC11 and then “star “connect to the bulk capacitor ground.
Schematic for recommended PCB layout
Schematic for recommended PCB layout
®
device, GND pin of IC11; the signal grounds from C13, C14, C15 and collector
®
IC11) to nearby trace: > 2.5mm
29
Schematic for recommended PCB layout
®
(refer to Figure 35):
CoolSET
ICE3BR1065J
28 Dec 2011
®
®
-F3R
device