SSD1852T2R1 ETC [List of Unclassifed Manufacturers], SSD1852T2R1 Datasheet - Page 32

• Manufacturer Part Number: SSD1852T2R1
• Description: LCD Segment / Common Driver With Controller CMOS
• Manufacturer: ETC [List of Unclassifed Manufacturers]

27
SSD1852
9.13 Set PWM and FRC
9.14 Set Segment Re-map
9.15 Set Icon Enable
9.16 Set Entire Display On/Off
9.17 Set Normal/Inverse Display
9.18 Set Power Save Mode
9.19 Start Internal Oscillator
9.20 Set Display On/Off
9.21 Set Page Address
9.22 Set COM Output Scan Direction
9.23 Set Modify-Read
number of levels in the pulse width modulation.
segment driver. It allows flexibility in layout during LCD module assembly. Refer to Figure 7.
address is set to Page 16. This is only one way to set the page address to 16. Therefore, when
writing data for the icon, ICONS control register ON instruction would be used to set the page
address to 16.
the contents of the display data RAM. This command has priority over normal/invert display. To
execute this command, Set Display On command must be sent in advance.
data of 1 indicates an “ON” pixel. While in invert display, a RAM data of 0 indicates an “ON”
pixel. The icon line is not affected by this command.
command to the chip.
Refer to figure 7.
control register ON/OFF command to set the page address to “16”.
module assembly.
data. The column address is still automatic increment due to write display data.
This command is used to select the number of frames used in frame rate control, and the
This command changes the mapping between the display data column address and
This command enable/disable the Icon display. When Icon display is enabled and page
This command forces the entire display, including the icon row, to be “ON” regardless of
This command sets the display to be either normal/inverse. In normal display, a RAM
This command is used to force the chip to enter Sleep Mode.
After POR, the internal oscillator is OFF. It should be turned ON by sending this
This command turns the display on/off, by the value of the LSB.
This command positions the page address to 0 to 15 possible positions in GDDRAM.
Set Page Address command cannot be used to set the page address to “16”. Use ICON
This command sets the scan direction of the COM output allowing layout flexibility in LCD
This command stops the automatic increment of the column address after read display
Rev 1.0
01/2003
SOLOMON