SSD1852T2R1 ETC [List of Unclassifed Manufacturers], SSD1852T2R1 Datasheet - Page 39

• Manufacturer Part Number: SSD1852T2R1
• Description: LCD Segment / Common Driver With Controller CMOS
• Manufacturer: ETC [List of Unclassifed Manufacturers]

SSD1852
9.35 Enable DMA mode
9.36 Set Start/End Column and Page address in DMA mode
data access returning to pre-set start column address once overflow (> end column address).
The page address will be incremented by column address overflow. The start column address,
end column address, start page address and end page address should set to 0,127,0,15
respectively before disable DMA mode.
address and column address should set to start page address and start column address after
set start/end column and page address.
This command enables the DMA mode. The column address will be incremented by each
This command set the column and page address parameter in DMA mode. The page
Rev 1.0
01/2003
Available write the data to GDDRAM
Set Start/End Column and Page address
e.g. 84H, 10H, 01H, 60H, 0CH
end column address = 96, end page address = 12)
Set page and column address
e.g. B1H, 11H, 00H
Reset Start/End Column and Page address
e.g. 84H, 00H, 00H, 7FH, 0FH
end column address = 127, end page address = 15)
(start column address = 16, start page address = 1,
(page address = 1, column address = 16)
(start column address = 0, start page address = 0,
Figure 13 - Sequence for disable the DMA mode.
Figure 12 - Sequence for setting the DMA mode.
Disable DMA mode (F4H, 01H)
Enable DMA mode (F4H, 05H)
SOLOMON
34