MS400 EXTECH [Extech Instruments Corporation.], MS400 Datasheet - Page 41

• Manufacturer Part Number: MS400
• Description: Handheld Digital Storage Oscilloscope & Multimeter
• Manufacturer: EXTECH [Extech Instruments Corporation.]

To measure the frequency of CH1 with Measurement 1 and the frequency of CH2 with
Measurement 2, perform the following:
Cursor Measurements
1. Press the MENU key; the function menu will be shown at the right of the screen.
2. Press the MENU UP or MENU DOWN key to select MEAS SET1. Five options
3. Press the F1 key to select the frequency measurement as CH1. The
4. Press the MENU UP or MENU DOWN key to select MEAS SET2. Five options
5. Press the F4 key to jump to the peak-to-peak measurement symbolized as CH2.
This oscilloscope allows the user to make manual cursor measurements of time and
voltage. The signal sources include Channel 1 (CH1), Channel 2 (CH2), MATH,
storage Address A and storage Address B.
The cursor measurement menus are listed and described in the following table:
Function
menus
Type
Signal
sources
appear at the bottom of the screen.
measurement window 1 on the screen turns red in color and shows the frequency
of CH1.
appear at the bottom of the screen.
The measurement window on the screen turns blue in color and shows the peak-
to-peak value of CH2.
The user can view a screen that looks similar to the following Figure 44.
Settings
Close
Voltage
Time
CH1, CH2, ATH,
address A and
address B.
Figure 44: Automatic Measurements
Description
Closes the cursor measurement
Displays the voltage cursor and menu
Displays the time cursor and menu
Selects the Waveform channel on which the
cursor measurement will be performed
41
MS400 Version 2.0 – December 2007