HT68F14 HOLTEK [Holtek Semiconductor Inc], HT68F14 Datasheet - Page 75

• Manufacturer Part Number: HT68F14
• Description: Enhanced I/O Flash Type MCU
• Manufacturer: HOLTEK [Holtek Semiconductor Inc]

Standard Type TM - STM
Rev. 1.10
HT68F13/HT68F14
Standard TM Operation
HT68F15
CTM
The Standard Type TM contains five operating modes, which are Compare Match Output,
Timer/Event Counter, Capture Input, Single Pulse Output and PWM Output modes. The Standard TM
can also be controlled with an external input pin and can drive one or two external output pins.
At its core is a 10-bit count-up counter which is driven by a user selectable internal or external clock
source. There are also two internal comparators with the names, Comparator A and Comparator P.
These comparators will compare the value in the counter with CCRP and CCRA registers. The CCRP
is three bits wide whose value is compared with the highest three bits in the counter while the CCRA is
the ten bits and therefore compares with all counter bits.
The only way of changing the value of the 10-bit counter using the application program, is to clear the
counter by changing the TnON bit from low to high. The counter will also be cleared automatically by
a counter overflow or a compare match with one of its associated comparators. When these conditions
occur, a TM interrupt signal will also usually be generated. The Standard Type TM can operate in a
number of different operational modes, can be driven by different clock sources including an input pin
and can also control an output pin. All operating setup conditions are selected using relevant internal
registers.
10-bit STM
Name
Standard Type TM Block Diagram
TM No.
75
1
Enhanced I/O Flash Type MCU
HT68F13/HT68F14/HT68F15
TM Input Pin
TCK1
TM Output Pin
TP1_0, TP1_1
February 9, 2011