S9S12G96F0VLH Freescale Semiconductor, S9S12G96F0VLH Datasheet - Page 1129

• Manufacturer Part Number: S9S12G96F0VLH
• Description: 16-bit Microcontrollers - MCU 16BIT 96K FLASH
• Manufacturer: Freescale Semiconductor

Specifications of S9S12G96F0VLH

• Rohs: yes
• Core: S12
• Processor Series: MC9S12G
• Data Bus Width: 16 bit
• Maximum Clock Frequency: 25 MHz
• Program Memory Size: 96 KB
• Data Ram Size: 8192 B
• On-chip Adc: Yes
• Operating Supply Voltage: 3.13 V to 5.5 V
• Operating Temperature Range: - 40 C to + 125 C
• Package / Case: LQFP-64
• Mounting Style: SMD/SMT

30.4.6.14 Erase Verify EEPROM Section Command
The Erase Verify EEPROM Section command will verify that a section of code in the EEPROM is erased.
The Erase Verify EEPROM Section command defines the starting point of the data to be verified and the
number of words.
Upon clearing CCIF to launch the Erase Verify EEPROM Section command, the Memory Controller will
verify the selected section of EEPROM memory is erased. The CCIF flag will set after the Erase Verify
EEPROM Section operation has completed. If the section is not erased, it means blank check failed, both
MGSTAT bits will be set.
Freescale Semiconductor
Register
FSTAT
Table 30-60. Erase Verify EEPROM Section Command FCCOB Requirements
Field margin levels must only be used during verify of the initial factory
programming.
Field margin levels can be used to check that Flash memory contents have
adequate margin for data retention at the normal level setting. If unexpected
results are encountered when checking Flash memory contents at field
margin levels, the Flash memory contents should be erased and
reprogrammed.
Table 30-61. Erase Verify EEPROM Section Command Error Handling
MGSTAT1
MGSTAT0
ACCERR
Error Bit
FPVIOL
CCOBIX[2:0]
000
001
010
MC9S12G Family Reference Manual, Rev.1.23
Set if CCOBIX[2:0] != 010 at command launch
Set if command not available in current mode (see
Set if an invalid global address [17:0] is supplied
Set if a misaligned word address is supplied (global address [0] != 0)
Set if the requested section breaches the end of the EEPROM block
None
Set if any errors have been encountered during the read or if blank check failed.
Set if any non-correctable errors have been encountered during the read or if
blank check failed.
Global address [15:0] of the first word to be verified
0x10
Number of words to be verified
CAUTION
NOTE
FCCOB Parameters
Global address [17:16] to
Error Condition
identify the EEPROM
block
192 KByte Flash Module (S12FTMRG192K2V1)
Table
30-27)
1131