IS25LQ016-JKLE-TR ISSI, IS25LQ016-JKLE-TR Datasheet - Page 27

• Manufacturer Part Number: IS25LQ016-JKLE-TR
• Description: Flash 16M 2.3-3.6V 104Mhz Serial Flash
• Manufacturer: ISSI

Specifications of IS25LQ016-JKLE-TR

• Rohs: yes
• Data Bus Width: 8 bit
• Memory Type: Flash
• Memory Size: 16 Mbit
• Architecture: Uniform
• Timing Type: Synchronous
• Interface Type: SPI
• Supply Voltage - Max: 3.6 V
• Supply Voltage - Min: 2.3 V
• Maximum Operating Current: 12 mA
• Operating Temperature: - 40 C to + 105 C
• Mounting Style: SMD/SMT
• Package / Case: WSON-8
• Organization: 2048 K x 8

DEVICE OPERATION (CONTINUED)
PAGE_PROG COMMAND (PAGE PROGRAM) OPERATION
The Page Program (PAGE_PROG) instruction allows
up to 256 bytes data to be programmed into memory in
a single operation. The destination of the memory to be
programmed must be outside the protected memory
area set by the Block Protection (BP2, BP1, BP0) bits.
A PAGE_PROG instruction which attempts to program
into a page that is write-protected will be ignored.
Before the execution of PAGE_PROG instruction, the
Write Enable Latch (WEL) must be enabled through a
Write Enable (WREN) instruction.
The PAGE_PROG instruction code, three address
bytes and program data (1 to 256 bytes) are input via
the Sl line. Program operation will start immediately
after the CE# is brought high, otherwise the
PAGE_PROG instruction will not be executed. The
internal control logic automatically handles the
programming voltages and timing. During a program
operation, all instructions will be ignored except the
RDSR instruction. The progress or completion of the
program operation can be determined by reading the
Figure 21. Page Program Sequence
Integrated Silicon Solution, Inc.- www.issi.com
Rev. 0A
2/1/2013
WIP bit in Status Register via a RDSR instruction. If
the WIP bit is “1”, the program operation is still in
progress. If WIP bit is “0”, the program operation has
completed.
If more than 256 bytes data are sent to a device, the
address counter rolls over within the same page, the
previously latched data are discarded, and the last 256
bytes data are kept to be programmed into the page.
The starting byte can be anywhere within the page.
When the end of the page is reached, the address will
wrap around to the beginning of the same page. If the
data to be programmed are less than a full page, the
data of all other bytes on the same page will remain
unchanged.
Note: A program operation can alter “1”s into “0”s, but
an erase operation is required to change “0”s back to
“1”s. A byte cannot be reprogrammed without first
erasing the whole sector or block.
IS25LQ016
27