STM8S105K6T3CTR STMicroelectronics, STM8S105K6T3CTR Datasheet - Page 15

• Manufacturer Part Number: STM8S105K6T3CTR
• Description: 8-bit Microcontrollers - MCU 8-bit MCU Access 16 MHz 32kb Flash
• Manufacturer: STMicroelectronics

Specifications of STM8S105K6T3CTR

• Product Category: 8-bit Microcontrollers - MCU
• Rohs: yes
• Core: STM8
• Data Bus Width: 8 bit

STM8S105xx
4.7
4.8
4.9
Watchdog timers
The watchdog system is based on two independent timers providing maximum security to
the applications.
Activation of the watchdog timers is controlled by option bytes or by software. Once activated,
the watchdogs cannot be disabled by the user program without performing a reset.
Window watchdog timer
The window watchdog is used to detect the occurrence of a software fault, usually generated
by external interferences or by unexpected logical conditions, which cause the application
program to abandon its normal sequence.
The window function can be used to trim the watchdog behavior to match the application
perfectly.
The application software must refresh the counter before time-out and during a limited time
window.
A reset is generated in two situations:
1. Timeout: At 16 MHz CPU clock the time-out period can be adjusted between 75 µs up to
2. Refresh out of window: The downcounter is refreshed before its value is lower than the
Independent watchdog timer
The independent watchdog peripheral can be used to resolve processor malfunctions due to
hardware or software failures.
It is clocked by the 128 kHZ LSI internal RC clock source, and thus stays active even in case
of a CPU clock failure
The IWDG time base spans from 60 µs to 1 s.
Auto wakeup counter
•
•
•
Beeper
The beeper function outputs a signal on the BEEP pin for sound generation. The signal is in
the range of 1, 2 or 4 kHz.
The beeper output port is only available through the alternate function remap option bit AFR7.
64 ms.
one stored in the window register.
Used for auto wakeup from active halt mode
Clock source: Internal 128 kHz internal low frequency RC oscillator or external clock
LSI clock can be internally connected to TIM3 input capture channel 1 for calibration
DocID14771 Rev 12
Product overview
15/124