TC58DVM72A1FT Toshiba, TC58DVM72A1FT Datasheet - Page 22

• Manufacturer Part Number: TC58DVM72A1FT
• Description: IC FLASH 128MBIT 50NS 48TSOP
• Manufacturer: Toshiba

Specifications of TC58DVM72A1FT

• Format - Memory: FLASH
• Memory Type: FLASH - Nand
• Memory Size: 128M (16M x 8)
• Speed: 50ns
• Interface: Serial
• Voltage - Supply: 2.7 V ~ 3.6 V
• Operating Temperature: 0°C ~ 70°C
• Package / Case: 48-TSOP
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

Auto Page Program
Auto Block Erase
the address and data have been input. The sequence of command, address and data input is shown below.
(Refer to the detailed timing chart.)
which follows the Erase Setup command “60H”. This two-cycle process for Erase operations acts as an ertra layer
of protection from aceidental erasure of data due to external noise. The device automatically executes the Erase
and Verify operations.
The device carries out an Automatic Page Program operation when it receives a “10H” Program command after
Data input
The Auto Block Erase operation starts on the rising edge of WE after the Erase Start command “D0H”
command
RY
RY
Data input
/
/
80
BY
BY
Selected
Figure 7. Auto Page Program operation
page
Address
60
Program
input
Block Address
input: 2 cycles
Data input
0 to 527
Erase Start
Reading & verification
command
command
Program
D0
10
page on the rising edge of WE following input of the “10H” command.
After programming, the programmed data is transferred back to the
register to be automatically verified by the device. If the programming
does not succeed, the Program/Verify operation is repeated by the device
until success is achieved or until the maximum loop number set in the
device is reached.
TC58DVM72A1FT00/ TC58DVM72F1FT00
TC58DAM72A1FT00/ TC58DAM72F1FT00
The data is transferred (programmed) from the register to the selected
Busy
completion of the operation.
RY
Status Read
Status Read
command
command
/
BY
70
70
automatically returns to Ready after
I/O
I/O
2003-01-24 22/34
Fail
Fail
Pass
Pass