ISL9301IRZ Intersil, ISL9301IRZ Datasheet - Page 10

• Manufacturer Part Number: ISL9301IRZ
• Description: IC CHRGR LI-ION HV SGL 10-TDFN
• Manufacturer: Intersil

Specifications of ISL9301IRZ

• Function: Charge Management
• Battery Type: Lithium-Ion (Li-Ion), Lithium-Polymer (Li-Pol)
• Voltage - Supply: 4.3 V ~ 10 V
• Operating Temperature: -40°C ~ 85°C
• Mounting Type: Surface Mount
• Package / Case: 10-VFDFN Exposed Pad
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

V
trickle charge current.
The IC moves to a fast charge constant current mode when
V
states in this mode depending on the output current. When
the sum of the output current and the fast charge current is
smaller than the input current limit, the IC enters the Fast
Charge state with the charge current set by R
output current and the fast charge current are greater than
the input current limit, the IC will enter the PPM mode, where
the charging current is reduced to a point such that the sum
of output current and the charging current equals to the input
current limit. If the output current by itself is greater than the
input current limit, the IC enters the Battery Discharge state,
where the battery is discharged to the system to supply a
part of the output demand.
When the battery voltage reaches 4.2V, the IC enters the CV
Charge state, where PPR is LO, CHG is LO and V
regulated at 4.5V. The battery is being charged at a constant
voltage while the charging current decreases.
When the charging current is reduced to the IMIN threshold,
the IC enters a Charge Complete state, where PPR is LO,
CHG is HI, V
continues to charge the battery.
When the timeout interval has elapsed after the Charge
Complete state, the IC will enter the Disabled state, where
the PPR is LO, CHG is HI, V
charger is OFF. After the Charge Complete state, if VBAT is
below the re-charge threshold, the IC will re-initialize and
start a new cycle.
OUT
BAT
reaches the V
is regulated at 4.5V, the charger is ON, delivering a
OUT
is regulated at 4.5V and the charger
MIN
threshold. There are 3 possible
OUT
10
is regulated at 4.5V and the
IREF
. When the
OUT
is
ISL9301
If the timeout limit is reached before the Charge Complete
state, the IC enters the Charger Fault state, where PPR is
LO, CHG is blinking, VOUT is regulated at 4.5V and the
charger is OFF. This state is latched until the input power is
removed and re-applied to start a new cycle.
Any time during the operation, if the die temperature reaches
the OTP threshold, the IC will enter the OTP state, where
PPR is LO, CHG is HI, and the charger is OFF. VOUT is
disconnected from VIN and connected to VBAT internally to
maintain system power need.
Summary of Output States
The output states under various fault conditions are
summarized in Table 1.
NOTES:
1. BATON: BATON Pin
2. OVP: Input Overvoltage Protection
3. OTP: Over-Temperature Protection
4. M1: Output Path MOSFET
5. M2: Battery Path MOSFET
TABLE 1. OUTPUT STATES UNDER FAULT CONDITIONS
Y
Y
N
Y
Y
N
N
OTP
Y
N
Y
Y
N
Y
N
OVP
BATON
H
H
H
L
L
L
X
Regulating
OFF
OFF
OFF
OFF
OFF
OFF
M1
Charging
July 2, 2008
ON
ON
ON
OFF
OFF
OFF
FN6435.2
M2