ICM7218DIJIR5254 Intersil, ICM7218DIJIR5254 Datasheet - Page 6

• Manufacturer Part Number: ICM7218DIJIR5254
• Description: IC DRIVER DECODER 8DIG 28-CERDIP
• Manufacturer: Intersil

Specifications of ICM7218DIJIR5254

• Display Type: LED
• Configuration: 7 Segment
• Digits Or Characters: 8 Digits
• Current - Supply: 700µA
• Voltage - Supply: 4 V ~ 6 V
• Operating Temperature: -40°C ~ 85°C
• Mounting Type: Through Hole
• Package / Case: 28-CDIP (0.600", 15.24mm)
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Interface: -

Inter Digit Blanking
A blanking time of approximately 10μs occurs between digit
strobes. This ensures that the segment information is correct
before the next digit drive, thereby avoiding display ghosting.
Driving Larger Displays
If a higher average drive current per digit is required, it is
possible to connect digit drive outputs together. For example,
by paralleling pairs of digit drivers together to drive a 4 digit
display, 5mA average segment drive current can be obtained.
Power Dissipation Considerations
Assuming common anode drive at V
with an average of 5 segments driven per digit, the average
current would be approximately 200mA. Assuming a 1.8V
drop across the LED display, there will be a 3.2V drop across
the ICM7218. The device power dissipation will therefore be
640mW, rising to about 900mW, for all ‘8’ ‘s displayed.
Caution: Position device in system such that air can
flow freely to provide maximum cooling. The common
cathode dissipation is approximately one-half that of the
common anode dissipation.
Sequential Addressing Considerations
(lCM7218A/B)
The control instructions are read from the input bus lines if
MODE is high and WRITE low. The instructions occur on 4
6
DD
= 5V and all digits on
FIGURE 4. TIMING DIAGRAM FOR ICM7218A/B
FIGURE 5. LOAD SEQUENCE ICM7218A/B
ICM7218
lines and are - DECODE/no Decode, type of Decode (if
desired), SHUTDOWN/no Shutdown and DATA COMlNG/not
Coming. After the control word has been written (with the Data
Coming instruction), display data can be written into memory
with each successive negative going WRITE pulse. After all
8-digit memory locations have been written to, additional
transitions of the WRITE input are ignored until a new control
word is written. It is not possible to change one individual digit
without refreshing the data for all the other digits.
Random Access Input Drive Considerations
(ICM7218C/D)
Control instructions are provided to the ICM7218C/D by a
single three level input terminal (Pin 9), which operates
independently of the WRITE pulse.
Data can be written into memory on the lCM7218C/D by
setting up a 3 bit binary code (one of eight) on the digit
address inputs and applying a low level to the WRITE pin.
For example, it is possible to change only digit 7 without
altering the data for the other digits. (See Figure 6).
Supply Capacitor
A 0.1μF plus a 47μF capacitor is recommended between
V
DD
and V
SS
to bypass display multiplexed noise.
February 15, 2007
FN3159.2