DS1821S Maxim Integrated Products, DS1821S Datasheet - Page 2

• Manufacturer Part Number: DS1821S
• Description: IC THERMOMETER/STAT PROG 8-SOIC
• Manufacturer: Maxim Integrated Products

Specifications of DS1821S

• Function: Thermometer, Thermostat
• Topology: Comparator, Register Bank
• Sensor Type: Internal
• Sensing Temperature: -55°C ~ 125°C
• Output Type: Digital
• Output Alarm: No
• Output Fan: No
• Voltage - Supply: 2.7 V ~ 5.5 V
• Operating Temperature: -55°C ~ 125°C
• Mounting Type: Surface Mount
• Package / Case: 8-SOIC (5.3mm Width), 8-SOP, 8-SOEIAJ
• Full Temp Accuracy: +/- 1 C
• Digital Output - Bus Interface: Serial (1-Wire)
• Digital Output - Number Of Bits: 8 bit
• Maximum Operating Temperature: + 125 C
• Minimum Operating Temperature: - 55 C
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

ORDER INFORMATION
ORDERING
NUMBER
DS1821
DS1821+
DS1821S
DS1821S/T&R
DS1821S+
DS1821S+T&R
Note: A “+” symbol will also be marked on the package.
+ Denotes lead-free package.
DETAILED PIN DESCRIPTIONS Table 1
*All pins not specified in this table are “No Connect” pins.
OVERVIEW
Figure 1 shows a block diagram of the DS1821 and pin descriptions are given in Table 1. The DS1821
can operate as a standalone thermostat with user-programmable trip-points or as 8-bit temperature sensor
with a 1-Wire digital interface. The open-drain DQ pin functions as the thermostat output for thermostat
operation and as the data I/O pin for 1-Wire communications. The 1-Wire interface provides user access
to the nonvolatile (EEPROM) thermostat trip-point registers (T
and the temperature register.
When configured as standalone thermostat, temperature conversions start immediately at power-up. In
this mode, the DQ pin becomes active when the temperature of the DS1821 exceeds the limit
programmed into the T
programmed into the T
The DS1821 uses Dallas’ exclusive 1-Wire bus protocol that implements bus communication with one
control signal. This system is explained in detail in the 1-Wire BUS SYSTEM section of this datasheet.
PR35
1
2
3
8-PIN
SO*
2
1
8
SYMBOL
DS1821
DS1821 (See Note)
DS1821S
DS1821S
DS1821S (See Note)
DS1821S (See Note)
L
GND
V
DQ
register.
H
DD
register, and remains active until the temperature drops below the limit
PACKAGE
MARKING
Ground pin.
Open drain data input/output pin – 1-Wire operation; Open drain
thermostat output pin –thermostat operation.
Power supply pin.
DS1821 in 3-pin PR35
DS1821 in 3-pin PR35
DS1821 in 208 mil 8-pin SO
DS1821 in 208 mil 8-pin SO, 2000 Piece Tape-and-Reel
DS1821 in 208 mil 8-pin SO
DS1821 in 208 mil 8-pin SO, 2000 Piece Tape-and-Reel
2 of 18
DESCRIPTION
H
and T
DESCRIPTION
L
), the status/configuration register,