IS-DEV KIT-8 NKK Switches, IS-DEV KIT-8 Datasheet - Page 6

• Manufacturer Part Number: IS-DEV KIT-8
• Description: SMARTSWITCH DEVELOPMENT KIT 8
• Manufacturer: NKK Switches
• Series: SmartSwitch™r

Specifications of IS-DEV KIT-8

• Main Purpose: Switches with Programmable Display
• Utilized Ic / Part: SmartSwitch™OLED Rocker Switch
• Primary Attributes: OLED Rocker Switch
• Description/function: SMARTSWITCH Development Kit
• Maximum Operating Temperature: + 70 C
• Operating Voltage: 2.7 V to 5.5 V
• For Use With: 360-2431 - SERIAL CBL RJ11-DB9 FOR DEV KIT360-2430 - POWER SUPPLY 240VAC FOR DEV KIT360-2429 - POWER SUPPLY 120VAC FOR DEV KIT
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Secondary Attributes: -
• Embedded: -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• For Use With/related Products: OLED Smartswitch Rocker
• Other names: 360-2421

IS-Dev Kit-8 User Manual
7850 East Gelding Drive • Scottsdale, AZ 85260-3420
4. Operational Overview
Power-up and Brightness Adjustment:
When the power is turned on, the OLED displays the image below and allows for brightness adjustment.
There are 16 level of brightness 0,1,2,3,4,5,6,7,8,9,A,B,C,D,E and F where F is the maximum brightness. The
level of brightness is displayed in the middle of image. After power up, the display is at the maximum
brightness level (F). Pressing the bottom switch will make the display dimmer. Pressing the top switch will
make the display brighter. The OLED rated life of 52,000 hours is based on the maximum brightness. The
dimmer the level is set the longer the life of the OLED. Any switch activity will keep the unit in this mode.
After 2.6 seconds of user inactivity the controller will move into the main operations mode.
Main Operational Mode
The IS-DEV KIT-8 is programmed with factory default images. The user can change the images and
programming through the use of attributes. The images are pictures to be displayed. The attributes are user
defined information on what image to display based on the switch activity and when the timer expires. After the
brightness adjustment mode the OLED Rocker displays the image at address 1 and uses the attribute
information of address 1. There is room for 65,535 images and attributes (address 1 to 65535) in memory.
The controller associates one address to each image and the display shows the image at the associated address.
Each address has a group of seven attributes which together is called an Attribute Block. The function of the
Attribute Block is to tell the controller what image to display next either when the switch associated with that
particular address is pressed or when the timer expires. These are called actions.
IS-Dev Kit 8 Users Manual A.doc
Page 6 of 31
Toll Free 1.877.2BUYNKK (877.228.9655) • Phone [phone] • Fax [phone]
www.nkkswitches.com • Email [e-mail]
1209