SI5324-EVB Silicon Laboratories Inc, SI5324-EVB Datasheet - Page 15

• Manufacturer Part Number: SI5324-EVB
• Description: BOARD EVALUATION SI5324
• Manufacturer: Silicon Laboratories Inc

Specifications of SI5324-EVB

• Main Purpose: Timing, Clock Multiplier
• Embedded: No
• Utilized Ic / Part: SI5324
• Primary Attributes: 2 Inputs, 2 Outputs
• Secondary Attributes: CML, CMOS, LVDS, LVPECL
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant, Lead free / RoHS Compliant

Note: Internal register names are indicated by underlined italics, e.g., INT_PIN. See Si5324 Register Map.
Pin #
21
22
23
25
24
26
27
SDA_SDO
Pin Name
CS_CA
A2_SS
SCL
SDI
A1
A0
I/O
I/O
I/O
I
I
I
I
Signal Level
LVCMOS
LVCMOS
LVCMOS
LVCMOS
LVCMOS
LVCMOS
Input Clock Select/Active Clock Indicator.
Input: In manual clock selection mode, this pin functions as the
manual input clock selector if the CKSEL_PIN is set to 1.
0 = Select CKIN1.
1 = Select CKIN2.
If CKSEL_PIN = 0, the CKSEL_REG register bit controls this func-
tion and this input tristates. If configured for input, must be tied high
or low.
Output: In automatic clock selection mode, this pin indicates which
of the two input clocks is currently the active clock. If alarms exist on
both clocks, CK_ACTV will indicate the last active clock that was
used before entering the digital hold state. The CK_ACTV_PIN reg-
ister bit must be set to 1 to reflect the active clock status to the
CK_ACTV output pin.
0 = CKIN1 active input clock.
1 = CKIN2 active input clock.
If CK_ACTV_PIN = 0, this pin will tristate. The CK_ACTV status will
always be reflected in the CK_ACTV_REG read only register bit.
Serial Clock.
This pin functions as the serial clock input for both SPI and I
modes.
This pin has a weak pull-down.
Serial Data.
In I
tional serial data port.
In SPI control mode (CMODE = 1), this pin functions as the serial
data output.
Serial Port Address.
In I
controlled address bits. The I
In SPI control mode (CMODE = 1), these pins are ignored.
These pins have a weak pull-down.
Serial Port Address/Slave Select.
In I
controlled address bit [A2].
In SPI control mode (CMODE = 1), this pin functions as the slave
select input.
This pin has a weak pull-down.
Serial Data In.
In I
In SPI control mode (CMODE = 1), this pin functions as the serial
data input.
This pin has a weak pull-down.
Preliminary Rev. 0.3
2
2
2
2
C control mode (CMODE = 0), this pin functions as the bidirec-
C control mode (CMODE = 0), these pins function as hardware
C control mode (CMODE = 0), this pin functions as a hardware
C control mode (CMODE = 0), this pin is ignored.
Description
2
C address is 1101 [A2] [A1] [A0].
Si5324
2
C
15