EVLVIPER28L-10W STMicroelectronics, EVLVIPER28L-10W Datasheet - Page 17

• Manufacturer Part Number: EVLVIPER28L-10W
• Description: EVAL BOARD FOR VIPER28LD 60KHZ
• Manufacturer: STMicroelectronics
• Series: VIPER™r
• Type: AC/DC Switching Convertersr

Specifications of EVLVIPER28L-10W

• Main Purpose: AC/DC, Primary Side
• Outputs And Type: 1, Isolated
• Power - Output: 12W
• Voltage - Output: 5V
• Current - Output: 2.4A
• Voltage - Input: 85 ~ 265VAC
• Regulator Topology: Flyback
• Frequency - Switching: 60kHz
• Board Type: Fully Populated
• Utilized Ic / Part: VIPer28
• Input Voltage: 85 V to 265 V
• Output Voltage: 5 V
• Product: Power Management Modules
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• For Use With/related Products: VIPER28LN
• Other names: 497-8840

VIPER28
7.4
7.5
7.6
Power down operation
At converter power down, the system loses regulation as soon as the input voltage is so low
that the peak current limitation is reached. The V
the V
energy transfers to the IC interrupted and consequently the V
Figure 23 on page
the start up sequence is inhibited and the power down completed. This feature is useful to
prevent converter’s restart attempts and ensures monotonic output voltage decay during the
system power down.
Auto restart operation
If after a converter power down, the V
is not inhibited and will be activated only when the V
V
generator restarts the V
V
fault condition. After a fault condition, the charging current, I
the 3 mA (typ.) of a normal start up converter phase. This feature together with the low
V
long repetition rate and the converter works safely with extremely low power throughput.
The
Figure 21. Timing diagram: behavior after short-circuit
Oscillator
The switching frequency is internally fixed to 60 kHz or 115 kHz. In both case the switching
frequency is modulated by approximately ±4 kHz (60 kHz version) or ±8 kHz
(115 kHz version) at 250 Hz (typical) rate, so that the resulting spread-spectrum action
distributes the energy of each harmonic of the switching frequency over a number of side-
band harmonics having the same energy on the whole but smaller amplitudes.
DD(RESTART)
DD(RESTART)
DD(RESTART)
I
DDch
V
DD(RESTART)
Figure 25
(0.6mA)
DDoff
V
V
V
V
V
DDoff
V
V
DDon
FBolp
I
FBlin
DD
DD
FB
DS
threshold (see
. The scenario above described is for instance a power down because of a
threshold (see
threshold ensures that, after a fault, the restart attempts of the IC has a very
shows the IC behavioral after a short-circuit event.
Short circuit occurs here
16. Later, if the V
DD
Table 7 on page
capacitor charging only when the V
Table 7 on page
Doc ID 15028 Rev 4
= 0.3 x T
IN
REPETITION
IN
is lower than V
is higher than V
6) the power MOSFET is switched OFF, the
6). This means that the HV start up current
DD
voltage drops and when it falls below
DD
DRAIN_START
voltage drops down the
DRAIN_START,
T
REPETITION
DDch
DD
DD
, is 0.6 mA (typ.) instead of
voltages decreases,
voltage drops below
(see
Operation descriptions
the start up sequence
Table 7 on page
time
time
time
17/32
time
6),