EVLVIPER28L-10W STMicroelectronics, EVLVIPER28L-10W Datasheet - Page 24

• Manufacturer Part Number: EVLVIPER28L-10W
• Description: EVAL BOARD FOR VIPER28LD 60KHZ
• Manufacturer: STMicroelectronics
• Series: VIPER™r
• Type: AC/DC Switching Convertersr

Specifications of EVLVIPER28L-10W

• Main Purpose: AC/DC, Primary Side
• Outputs And Type: 1, Isolated
• Power - Output: 12W
• Voltage - Output: 5V
• Current - Output: 2.4A
• Voltage - Input: 85 ~ 265VAC
• Regulator Topology: Flyback
• Frequency - Switching: 60kHz
• Board Type: Fully Populated
• Utilized Ic / Part: VIPer28
• Input Voltage: 85 V to 265 V
• Output Voltage: 5 V
• Product: Power Management Modules
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• For Use With/related Products: VIPER28LN
• Other names: 497-8840

Operation descriptions
7.12
24/32
Extra power management function (EPT)
Some applications need an extra power for a limited time window during which the converter
regulation has to be guaranteed. The extra power management function allows to design a
converter that can satisfy this request and is provided by the EPT pin, see
page 8
This function requires the use of a capacitor on EPT pin (C
discharged by means of a 5 µA current cycle by cycle. When the drain current raises over
85% of Idlim value, see I
while when the drain current is below I
reaches the V
After the converter shut down, the V
threshold (typ. 14.5 V) and according to the auto restart operation
(see
threshold (typical, 4.5 V) in order to charge again the V
operation is enabled again only when the voltage on EPT pin, drop below the V
(typical, 0.6 V). The low C
ensures safe operations and avoids overheating in case of repeated overload events. The
value of C
can be connected to GND if the function is not used.
Section 7.5 on page 17
.
EPT
EPT
has to be selected in order to prevent the device overheating. The EPT pin
threshold (typical, 4 V), the converter is shut down.
DLIM_EPT
EPT
) the VDD pin voltage have to fall below the V
discharge current in combination with its low restart threshold,
Doc ID 15028 Rev 4
(
Table 8 on page 7
DD
DLIM_EPT
voltage will drop below the V
discharges the capacitor. If C
), the current generator charges C
DD
capacitor. Moreover the PWM
EPT
) that is charged or
DD(ON)
DD(RESTART)
Table 8 on
start up
EPT
EPT(RESTART)
‘s voltage
VIPER28
EPT