EVL6566A-75WADP STMicroelectronics, EVL6566A-75WADP Datasheet - Page 31

• Manufacturer Part Number: EVL6566A-75WADP
• Description: BOARD EVAL FOR L6566A
• Manufacturer: STMicroelectronics
• Type: Power Factor Correctionr

Specifications of EVL6566A-75WADP

• Main Purpose: AC/DC, Primary and Secondary Side with PFC
• Outputs And Type: 1, Isolated
• Power - Output: 75W
• Voltage - Output: 19V
• Current - Output: 4A
• Voltage - Input: 90 ~ 264VAC
• Frequency - Switching: 65kHz
• Board Type: Fully Populated
• Utilized Ic / Part: L6563, L6566A, TSM1014
• Input Voltage: 90 V to 264 V
• Output Voltage: 19 V
• Dimensions: 78 mm x 174 mm
• Product: Power Management Modules
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Regulator Topology: -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• For Use With/related Products: L6563, L6566A
• Other names: 497-6449

L6566A
5.8
Figure 18. Hiccup-mode OCP: timing diagram
PFC interface
The device is specifically designed to minimize converter’s losses under light or no-load
conditions, and a special function has been provided to help the designer meet energy
saving requirements even in power-factor-corrected systems where a PFC pre-regulator
precedes the isolated DC-DC converter.
Actually EMC regulations require compliance with low-frequency harmonic emission limits
at nominal load; no limit is envisaged when the converter operates with a light load. Then
the PFC pre-regulator can be turned off, thus saving the no-load consumption of this stage
(0.5÷1 W).
To do so, the L6566A provides the Vcc_PFC pin (6): this pin is internally connected to the
Vcc pin (5) via a PNP transistor, normally closed, that opens when the voltage V
below V
FF operation is selected. This pin is intended for supplying the PFC controller of the pre-
regulator as shown in
IC will stop if an external failure causes the pin to be overloaded for too long time or shorted
to ground.
OCP latch
Vcc_PFC
Vcc_OK
(pin 6)
(pin 5)
(pin 7)
(pin 4)
Vcc
Vcc
COMPO
V
GD
Vcc
Vcc
CS
restart
OFF
ON
, a threshold internally set at a value depending on whether QR operation or
1.5 V
Figure 16 on page 28
Secondary diode is shorted here
. The switch is thermally protected, so that the
Application information
COMP
t
t
t
t
t
t
falls
31/51