EVL6566A-75WES4 STMicroelectronics, EVL6566A-75WES4 Datasheet - Page 18

• Manufacturer Part Number: EVL6566A-75WES4
• Description: BOARD DEMO FOR L6563/LL6566A
• Manufacturer: STMicroelectronics
• Type: Power Factor Correctionr

Specifications of EVL6566A-75WES4

• Main Purpose: AC/DC, Primary and Secondary Side with PFC
• Outputs And Type: 1, Isolated
• Power - Output: 75W
• Voltage - Output: 19V
• Current - Output: 4A
• Voltage - Input: 90 ~ 264VAC
• Regulator Topology: Flyback
• Board Type: Fully Populated
• Utilized Ic / Part: L6563, L6566A, TSM1014
• Input Voltage: 90 V to 264 V
• Output Voltage: 19 V
• Dimensions: 78 mm x 170 mm
• Product: Power Management Modules
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Frequency - Switching: -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• For Use With/related Products: L6563S, L6566A
• Other names: 497-8834

Application information
5.1
18/51
If FF operation is selected:
1.
Equation 1
2.
The L6566A is specifically designed for flyback converters operated from front-end power
factor correction (PFC) stages in applications supposed to comply with EN61000-3-2 or
JEITA-MITI regulations. Pin 6 (Vcc_PFC) provides the supply voltage to the PFC control IC.
High-voltage start-up generator
Figure 5
It is made up of a high-voltage N-channel FET, whose gate is biased by a 15 MΩ resistor,
with a temperature-compensated current generator connected to its source.
Figure 5.
FF mode from heavy to light load. The system operates exactly like a standard current
mode, at a frequency f
DCM and CCM transformer operation are possible, depending on whether the power
that it processes is greater or less than:
where Vin is the input voltage to the converter, V
regulated output voltage times the primary-to-secondary turn ratio) and Lp the
inductance of the primary winding. Pin
continuous to discontinuous operation mode of the transformer.
Burst-mode with no or very light load. This kind of operation is activated in the same
way and results in the same behavior as previously described for QR operation.
shows the internal schematic of the high-voltage start-up generator (HV generator).
High-voltage start-up generator: internal schematic
L6566A
Vcc_OK
sw
determined by the externally programmable oscillator: both
Pin
15 M
T
T
CONTROL
=
is the power level that marks the transition from
HV_EN
⎛
⎜ ⎜
⎝
Vin
GND
3
Vin
f 2
sw
+
V
V
1
R
Lp
HV
R
R
I
charge
I
HV
the reflected voltage (i.e. the
⎞
⎟ ⎟
⎠
2
5
Vcc
L6566A