M30622SAFP#U5 Renesas Electronics America, M30622SAFP#U5 Datasheet - Page 611

• Manufacturer Part Number: M30622SAFP#U5
• Description: IC M16C MPU ROMLESS 100QFP
• Manufacturer: Renesas Electronics America
• Series: M16C™ M16C/60r

Specifications of M30622SAFP#U5

• Core Processor: M16C/60
• Core Size: 16-Bit
• Speed: 16MHz
• Connectivity: SIO, UART/USART
• Peripherals: DMA, PWM, WDT
• Number Of I /o: 50
• Program Memory Type: ROMless
• Ram Size: 3K x 8
• Voltage - Supply (vcc/vdd): 4.2 V ~ 5.5 V
• Data Converters: A/D 10x10b, D/A 2x8b
• Oscillator Type: Internal
• Operating Temperature: -20°C ~ 85°C
• Package / Case: 100-QFP
• For Use With: 867-1000 - KIT QUICK START RENESAS 62PM3062PT3-CPE-3 - EMULATOR COMPACT M16C/62P/30P
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Eeprom Size: -
• Program Memory Size: -

Appendix 5
2-292
1.4 Oscillator concerns
Figure 1.4.1. Wiring for a large current signal line
Figure 1.4.2. Wiring of signal lines where potential levels change frequently
Take care to prevent an oscillator that generates clocks for a microcomputer operation from being affected
by other signals.
1.4.1 Keeping oscillator away from large current signal lines
1.4.2 Installing oscillator away from signal lines where potential levels change frequently
Install a microcomputer (and especially an oscillator) as far as possible from signal lines where a current
larger than the tolerance of current value flows.
In the system using a microcomputer, there are signal lines for controlling motors, LEDs, and thermal
heads or others. When a large current flows through those signal lines, strong noise occurs because of
mutual inductance.
Install an oscillator and a connecting pattern of an oscillator away from signal lines where potential levels
change frequently. Also, do not cross such signal lines over the clock lines or the signal lines which are
sensitive to noise. Or do not stretch long such signal lines parallelly to these said lines.
Signal lines where potential levels change frequently (such as the TA
lines at signal rising edge or falling edge. If such lines cross over a clock line, clock waveforms may be
deformed, which causes a microcomputer failure or a program runaway.
Reason
Reason
Mutual inductance
Do not cross
Large
current
M
GND
N.G.
Microcomputer
V
X
X
SS
IN
OUT
X
TA
X
V
OUT
IN
SS
OUT
SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER
OUT
pin signal line) may affect other
M16C / 62A Group
Mitsubishi microcomputers