SDSXA-016G-000000 SanDisk, SDSXA-016G-000000 Datasheet - Page 37

• Manufacturer Part Number: SDSXA-016G-000000
• Description: SSD 2.5" SATA 16GB
• Manufacturer: SanDisk
• Series: SSD SATAr
• Type: Flash Diskr

Specifications of SDSXA-016G-000000

• Memory Size: 16GB
• Memory Type: FLASH - Nand
• Density: 16GByte
• Operating Temperature (min): -40C
• Operating Temperature (max): 85C
• Package Type: Not Required
• Operating Temperature Classification: Industrial
• Programmable: Yes
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: FFD-25-SATA-16-X-A-P; FFD-25-SATA-16-X-A-P



10.4. Installation
10.4.1.
In order to install the SSD in your system, ensure that you have the following items:


10.4.2.
10.4.3.
The SSD can be installed in the system in any mounting position. Unlike rotating disks that have
an axis of rotation, the SSD is not susceptible to damage due to its orientation.
Note: It is not necessary to perform a low-level format on the SSD. The drive is shipped low-
10.4.3.1 Installing the SSD in a PC Environment
To install the SSD:
1. Power down the PC and remove the cover.
2. Mount the SSD in a free drive bay.
3. Connect a cable between the SSD and the host.
4. Close the PC cover and power on the PC.
5. The host BIOS sign-on message will appear and display a key sequence to enter the BIOS
You are now ready to use the SSD. If you encounter any problems, refer to Section ‎ 1 1 for
troubleshooting information.
10.4.3.2 Using the SSD in an MS-DOS-Based Platform
After installing the SSD (as described in Section ‎ 1 0.4.3), it must be installed as a disk drive
under DOS. Run the DOS commands listed below and follow the instructions displayed for each
command. For more information regarding the DOS commands, refer to your DOS manual.
1. Run the DOS FDISK program to partition the SSD.
2. Verify that the partition is active and ready for formatting.
3. Run the DOS FORMAT command to high-level format the SSD.
2
Never switch DC power to the drive by plugging an electrically live source cable into the
drive‟s power connector.
Pay attention to the cable polarity whenever connecting the drive to the cable.
System mounting hardware
The cable size may be 30 to 26 AWG. The cable maximum length should be one meter.
setup. Set up the BIOS to recognize the SSD (refer to the BIOS documentation for the disk
installation procedure).
level formatted and ready for use.
System Requirements
SSD Configuration
Installation
Product Specification and User Manual
SSD (Formerly FFD) Serial ATA 2.5"
42-PS-0605-00 Rev. 1.3