C500BC061 Omron, C500BC061 Datasheet - Page 32

• Manufacturer Part Number: C500BC061
• Description: BACKPLANE
• Manufacturer: Omron

Specifications of C500BC061

• Leaded Process Compatible: No
• Peak Reflow Compatible (260 C): No
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

Wiring RS-232C and RS-422 Cable Connectors
1-6-2
16
Soldering
Preparation for Connecting Unshielded Cable to FG
1, 2, 3... 1.
1, 2, 3... 1.
The procedures outlined in the list below correspond to the following diagrams.
2.
3.
4.
5.
Observe the following when soldering the prepared wires onto the connectors.
2.
3.
4.
Cut the cable to the required length.
Use a razor blade to cut away the sheath: 25 mm for RS-422 cable; 40 mm
for RS-232C cable.
Use scissors to cut away the exposed braiding.
Use wire strippers to remove the insulation from the last 5 mm of all wires.
Wrap insulating tape over the top and end of the the cut sheath.
Place heat-shrinking tubes over all wires, far enough away from the end so
as not to interfere with the soldering.
Pre-solder all wires and connector terminals.
Solder wires, inserting 4 mm of the exposed 5 mm of wire into the connector
terminal.
Move the heat-shrinking tubes onto the soldered area and shrink them into
place.
1 mm
Heat-shrinking tube
(Internal diameter
1.5mm, =10)
Heat-shrinking tube
Electrician’s
tape
Soldering iron
Section 1-6