C500BC061 Omron, C500BC061 Datasheet - Page 44

• Manufacturer Part Number: C500BC061
• Description: BACKPLANE
• Manufacturer: Omron

Specifications of C500BC061

• Leaded Process Compatible: No
• Peak Reflow Compatible (260 C): No
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

C200H Host Link Units
Command Levels
2-1-3
2-1-4
PC Mode on Applying Power with the Host Link Unit Mounted
28
RUN
RCV
XMT
ERROR
With no CPU-mounted device
With CPU-mounting Host Link Unit
With CPU-mounting peripheral device
With Programming Console
Indicator
and Host Link Unit setting
Indicators
PC Operating Modes
System configuration
1, 2, 3... 1.
Note Commands valid for each level are listed in 3-1 Command Levels.
Note 1. Transfer errors include parity, framing, overrun, and FCS errors.
ON (Multiple-link):
If set to ON, up to 32 Host Link Units can be connected to one host computer. The
unit number and FCS must be specified, even if only one Host Link Unit is con-
nected to the host computer. When using Ladder Support Software, LSS, the
switch must be set to ON.
2.
3.
2. Operation of the Unit is stopped when the RUN indicator is OFF or blinking.
3. Refer to 5-4 Troubleshooting for details on correcting the following problems.
The operating mode of the PC depends on the Memory Unit’s Initial Mode set-
ting, the RUN/STOP on the any CPU-mounted Host Link Unit, and the status of
any peripheral device connected to the PC. Refer to the following table for de-
tails.
ON when the Unit is operating. Depending on the settings of switches 1 to 4, this
indicator will blink when an error occurs. (See notes.)
ON when the Host Link Unit is receiving data.
ON when the Host Link Unit is transmitting data.
Goes ON when a transfer error is detected (See note 1.); goes OFF when a new
command is received normally.
Goes ON when an error is detected in communications with the CPU. The RUN
indicator will blink in this case. (See note 2.)
Restart the Unit after setting switches 1 to 4 correctly.
• The RUN indicator does not light.
• The Host Link Unit’s RCV indicator does not light when data is transmitted
• The RCV indicator lights, but the XMT indicator does not.
• The ERROR indicator lights.
• The XMT indicator lights, but the host computer does not receive the data.
Enables data areas to be read and, when the CPU has been correctly set
via the SC (Status Write) command, data can also be written.
Enables program transfers and reading or writing of I/O tables.
I/O READs can be performed and I/O tables can be registered. The Com-
mand Level should be set to “1, 2, 3” for running LSS software, program
transfers, etc. Other levels may be used for Systems Control Software,
monitoring, Data Acquisition Software, etc.
from the host computer.
RUN
STOP
RUN
RUN
PROGRAM
PROGRAM
The mode is determined by the mode selector on the Console,
i.e., RUN, MONITOR or PROGRAM.
Normal (OFF)
Memory Unit Initial Mode setting
Function
RUN
Run (ON)
Section 2-1