CV500-MC221 Omron, CV500-MC221 Datasheet - Page 51

• Manufacturer Part Number: CV500-MC221
• Description: SERVO CONTROL MODULE
• Manufacturer: Omron

Specifications of CV500-MC221

• Leaded Process Compatible: No
• Peak Reflow Compatible (260 C): No
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

Note 2. Even when bit No. 0 of the set up parameter No. 1 is set to “1,” the [Servo Off] switch is valid.
Note 3. When the Servo Driver is turned ON/OFF with the external signal, the [Base Block] and [Run]
Note [OK] can be selected instead of pressing the Return Key.
Note 1. The UE model cannot make jog speed changes, and the jog speed is fixed to 500 rpm.
1. Opening the Job Speed Setting Window
2. Setting the Jog Speeds (See Note 1)
Changing Jog Speeds
Jog Speed Setting window opens.
Jog Speed Setting window is closed and Jog Operation window is restored.


Confirm that the [Jog Speed] display has been changed.
Changing the jog speed also changes user parameter of the Servo Driver. However, parameters
registered on the IBM PC/AT or compatible memory will remain unchanged.
Click on [Set].
Select [Set] using the Tab Key. Press either the Space Key or Return Key.
Click on [Jog Speed]. Type the desired jog speed setting, then press the Return Key.
Select [Jog Speed] using the Tab Key. Type the desired jog speed setting, then press the Return
Key.
However, the Servo Driver will turn back ON if the Jog Operation window is closed.
When the RUN signal is input (ON) from outside, the [Servo Off] switch is invalid regardless of
parameter setting.
displayed inside the Jog Operation window may not be consistent with its real situation.
Chapter 5