CV500-MC221 Omron, CV500-MC221 Datasheet - Page 53

• Manufacturer Part Number: CV500-MC221
• Description: SERVO CONTROL MODULE
• Manufacturer: Omron

Specifications of CV500-MC221

• Leaded Process Compatible: No
• Peak Reflow Compatible (260 C): No
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

Note 1. [OK] can be selected instead of pressing the Return Key.
Note 2. In general, the jog speed should be at least 500 (r/min).
Note 3. The jog speed set here is not written to the Servo Driver’s User Parameter.
Note When bit No. 0 of the setup parameter No. 1 is set to “1,” there is no need to select [Servo On]
3. Setting the Mechanical Rigidity
4. Opening the Jog Speed Setting Window
5. Setting the Jog Speed
6. Selecting the [Servo On]
7. Selecting Direction of Rotation
Note The UE model cannot make jog speed changes, and the jog speed is fixed to 500 rpm.
Mechanical Rigidity window closes and Auto Tuning window is restored.
Jog Speed Setting window opens.
Run is displayed.
because the Servo Driver is normally in servo on status. The situation is the same as when the
RUN signal is input (ON) from outside.
Click on the desired mechanical rigidity setting. Click on [OK].
Select the [Mechanical Rigidity] list using the Tab Key. Select the mechanical rigidity using the Up
and Down Cursor Keys, then press the Return Key.
Click on [Set] to the right of [Jog Speed].
Select [Set] to the right of [Jog Speed] using the Tab Key. Press the Space Key or Return Key.
Click on [Jog Speed]. Type the desired jog speed setting, then press the Return Key.
Select [Jog Speed] using the Tab Key. Type the desired jog speed settings, then press the Return
Key.
Click on [Servo On].
Select [Servo On] using the Tab Key. Press the Space Key or Return Key.
Move the mouse cursor to [Forward] or [Reverse].
Chapter 5