PAXDR000 Red Lion Controls, PAXDR000 Datasheet - Page 22

• Manufacturer Part Number: PAXDR000
• Description: AC, Dual Rate, Upgradeable Red
• Manufacturer: Red Lion Controls
• Type: Rate/Totalizerr

Specifications of PAXDR000

• Accuracy: ± (0.01% of Input Signal Frequency)
• Cut Out, Panel: 3.62W x 1.77H Inches
• Dimensions: 3.80W x 1.95H Inches
• Display Digit Height: .56 Inches
• Display Type: LED Adjustable
• Function: Rate/Totalizer
• Input Type: Switch Selectable Pulse
• Keypad Type: 3 Programmable Function (5 Keys Total)
• Number Of Digits: Rate = 5, Totalizer = 8
• Primary Type: Electronic
• Range, Measurement: Rate = 0 to 99999, Totalizer = ±99999999
• Special Features: Programmable Function Keys
• Termination: Cage Clamp
• Voltage, Supply: 85 to 250 VAC
• Lead Free Status / Rohs Status: RoHS Compliant part


each time the setpoint value is reached. The automatic reset can occur at output
start (
appear if the Totalizer Setpoint Action is Timed Out. This reset may be different
from the Totalizer Reset Action selected in Module 4.
SELECTION

Assignment (
assigned totalizer is reset by a setpoint generated Totalizer Auto reset.






This parameter automatically resets the Setpoint Assigned Totalizer (A or B)
Select



) or output end (
LOW ACTING WITH NO DELAY
LOW ACTING WITH DELAY
SETPOINT RESET WITH DISPLAY RESET
ACTION
No Auto Reset
Reset to Zero at the Start of output activation.
Reset to Count Load Value at the Start of output activation
Reset to Zero at the End of output activation (timed out only)
Reset to Count Load at the End of output activation (timed out only)

, so the setpoint output will deactivate (reset) when the Setpoint




) totalizer display resets. Note: The output will not reset if the
TOTALIZER AUTO RESET


). The reset at output end selections will only




SETPOINT (ALARM) FIGURES FOR RATE


(For Reverse Action, The Alarm state is opposite.)
HIGH ACTING WITH NO DELAY
HIGH ACTING WITH DELAY
22

activates. (Example: SP1 deactivates when SP2 activates and SP4 when SP1
activates.) The last setpoint will wrap around to the first.


activates and then times out (deactivates). This function may only be used if the
SPn+1 is programmed for Setpoint Action of
when SP2 is activated and then times out.) The last setpoint will wrap around
to the first.

Select
Select
SETPOINT RESET WHEN SPn+1 DEACTIVATES


SETPOINT RESET WHEN SPn+1 ACTIVATES
, so the setpoint output will deactivate (reset) when SPn +1
, so the setpoint output will deactivate (reset) when SPn +1






LOW ACTING WITH TIMEOUT
HIGH ACTING WITH TIMEOUT



. (Example SP1 deactivates