W352-E1-06 Omron, W352-E1-06 Datasheet - Page 168

• Manufacturer Part Number: W352-E1-06
• Description: Product Manual
• Manufacturer: Omron

Removing EEPROM
CPM1, CPM1A, CPM2A,
CQM1, and SRM1 (-V2)
PCs
CPM2C and CQM1H PCs
Peripheral Port
Communications
Settings
6-3-2 PC Connections
Handling
!
!
Caution
Caution
Note If pin 1 on the CPM2C or pin 5 on the CQM1H is OFF, connection is still possible if
Lift up the lock lever and detach the EEPROM.
Mount the EEPROM to the CPM1-EMU01-V1 before connecting the
CPM1-EMU01-V1 to the PC.
Do not disconnect the CPM1-EMU01-V1 from the PC when the indicator is blink-
ing green.
When connecting to the CPM1, CPM1A, CPM2A, CQM1 or SRM1 (-V2),insert
the connector into the peripheral port making sure that the connector is oriented
correctly.
• Insert the connector until it securely locks into place.
• Connections are not possible to the RS-232C port or any other port.
When connecting to the CPM2C or CQM1H, connect to the peripheral port via
the CPM2C-CN111 or CS1W-CN114 Connecting Cable. Also, set the pins on
the CPU Unit’s DIP switch as follows:
the peripheral port is set to the defaults.
The peripheral port must be set to the default communications settings shown
below.
CPM2C
CQM1H
Start bit: 1
Data bits: 7
Stop bits: 2
Parity: Even
Baud rate: 9,600 bps
Pin 1: ON (see note)
Pin 2: ON
Pin 5: ON (see note)
Pin 7: ON
Connection to CPM2A
Section
149
6-3