UDS200-NL-01 Lantronix, UDS200-NL-01 Datasheet - Page 31

• Manufacturer Part Number: UDS200-NL-01
• Description: Ethernet Modules & Development Tools NON LABEL VERSION OF UDS200-01
• Manufacturer: Lantronix
• Type: Device Serversr

Specifications of UDS200-NL-01

• Data Rate: 200 Kbps
• Product: Modules
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

Modem Mode
Command
ATDTx.x.x.x,pppp
or
ATDTx.x.x.x/pppp
ATDTx.x.x.x
ATD0.0.0.0
ATD
ATDx.x.x.x
ATH
ATDTx.x.x.x,pppp
or
ATDTx.x.x.x/pppp
ATS0=n
ATEn
ATVn
Note:
like ATE0 or ATV. It does not recognize; compound commands such as
ATE0V1. All other AT commands with Modem Mode set to full verbose
acknowledge with an OK, but the unit takes no action.
Remote IP Address
This is the destination IP address used with an outgoing connection.
Remote Port
The remote TCP port number must be set for the unit to make outgoing connections.
This parameter defines the port number on the target host to which a connection is
attempted.
Note:
purposes, use the remote port number 23 (Internet standard port number for
Telnet services).
The unit only recognizes these AT commands as single commands
To connect an ASCII terminal to a host using the unit for login
Function
Makes a connection to an IP address (x.x.x.x) and a remote port number
(pppp).
Makes a connection to an IP address (x.x.x.x) and the remote port number
defined within the unit.
Forces the unit into Monitor Mode if a remote IP address and port number
are defined within the unit.
Forces the unit into Monitor Mode if a remote IP address and port number
are not defined within the unit.
Makes a connection to an IP address (x.x.x.x) and the remote port number
defined within the unit.
Hangs up the connection (Entered as +++ATH ).
Makes a connection to an IP address (x.x.x.x) and a remote port number
(pppp).
Enables or disables connections from the network going to the serial port:
Enables or disables character echo and responses:
Enables 1-character response or full verbose:
n=0 disables the ability to make a connection from the network to the
serial port.
n=1-9 enables the ability to make a connection from the network to the
serial port.
n>1-9 is invalid.
n=0 disables character echo and responses.
n=1 enables character echo and responses.
n=0 enables 1-character response.
n=1 enables full verbose.
Table 5-7. Modem Mode Commands
30