UDS200-NL-01 Lantronix, UDS200-NL-01 Datasheet - Page 40

• Manufacturer Part Number: UDS200-NL-01
• Description: Ethernet Modules & Development Tools NON LABEL VERSION OF UDS200-01
• Manufacturer: Lantronix
• Type: Device Serversr

Specifications of UDS200-NL-01

• Data Rate: 200 Kbps
• Product: Modules
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

The unit performs a power reset after the firmware has been loaded and stored.
Using Another Unit
To distribute firmware to another unit over the network:
1. Enter the host unit's Monitor Mode (see
2. Send the firmware to the receiving unit using the SF command, where x.x.x.x is
After loading and storing the firmware, the receiving unit performs a power reset
Note:
DeviceInstaller.
Using the Serial Port
The following procedure is for using the HyperTerminal software application. This
procedure takes about 10 minutes.
Note:
power while reprogramming will result in a corrupt program image and
a nonfunctional unit.
To download firmware from a computer using the unit’s serial port:
1. Enter Monitor Mode using the serial port (see
2. Download the firmware to the unit using the DL command.
3. Select Send Text File and select the U200*.HEX file to be downloaded. The
4. After receiving the final record, the unit checks the integrity of the firmware image
Port
the receiving unit's IP address.
downloaded file must be the .HEX (ASCII) version.
before programming the new firmware in the flash ROM. The following message
displays when the firmware upgrade is complete.
Do not switch off the power supply during the update. A loss of
You can only update your unit’s internal Web interface using TFTP or
on page 41).
Figure 6-3. Firmware Upgrade Screen Display
Figure 6-2. Sending Firmware to another Unit
*** NodeSet 2.0 ***
0>DL
02049 lines loaded.
SF x.x.x.x
39
Entering Monitor Mode Using the Serial
7: Using Monitor
Mode).