DS26514DK Maxim Integrated Products, DS26514DK Datasheet - Page 161

• Manufacturer Part Number: DS26514DK
• Description: Power Management Modules & Development Tools 4-Port T1-E1-J1 Tran Transceiver Demo Kit
• Manufacturer: Maxim Integrated Products

Specifications of DS26514DK

• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

Register Name:
Register Description:
Register Address:
Bit #
Name
Default
This register will report the received Sa6 codeword per ETS 300 233. The bits are monitored on a submultiframe
asynchronous basis, so the pattern reported could be one of multiple patterns that would represent a valid
codeword. The table below indicates which patterns reported in this register correspond to a given valid Sa6
codeword.
Bits 3 to 0: Sa6 Codeword Bit (Sa6n)
Register Name:
Register Description:
Register Address:
Bit #
Name
Default
Bit 7: Framer Enable (FRM_EN). This bit must be set to the desired state before writing INIT_DONE.
Bit 6: Initialization Done (INIT_DONE). The user must set this bit once he has written the configuration registers.
The host is required to write or clear all device registers prior to setting this bit. Once INIT_DONE is set, the
DS26514 will check the FRM_EN bit and, if enabled, will begin operation based on the initial configuration.
Bit 5: Disable Receive-Side Synchronizer (DRSS). This bit must be set to the desired state before writing
INIT_DONE.
Bit 1: Soft Reset (SFTRST). Level sensitive “soft” reset. Should be taken high, then low to reset the receiver.
Note: This reset does not clear the registers.
Bit 0: Receiver T1/E1 Mode Select (T1/E1). Sets operating mode for receiver only! This bit must be set to the
desired state before writing INIT_DONE.
Rev: 101608
VALID Sa6 CODE
0 = Framer disabled—held in low-power state.
1 = Framer enabled—all features active.
0 = Synchronizer enabled.
1 = Synchronizer disabled.
0 = Normal operation.
1 = Reset the receiver.
0 = T1 operation.
1 = E1 operation.
Sa6_C
Sa6_A
Sa6_E
Sa6_F
Sa6_8
FRM_EN
—
7
0
7
0
INIT_DONE
Sa6CODE
Received Sa6 Codeword Register
06Fh + (200h x (n - 1)) : where n = 1 to 4
RMMR
Receive Master Mode Register
080h + (200h x (n - 1)) : where n = 1 to 4
—
6
0
6
0
POSSIBLE REPORTED
1000, 0100, 0010, 0001
1110, 0111, 1011, 1101
110, 0110, 0011, 1001
PATTERNS
1010, 0101
DRSS
—
5
0
1111
5
0
—
4
0
—
4
0
Sa6n
3
0
—
3
0
DS26514 4-Port T1/E1/J1 Transceiver
Sa6n
2
0
—
2
0
SFTRST
Sa6n
1
0
1
0
161 of 305
Sa6n
T1/E1
0
0
0
0