TLE52052GPNT Infineon Technologies, TLE52052GPNT Datasheet - Page 6

• Manufacturer Part Number: TLE52052GPNT
• Manufacturer: Infineon Technologies

Specifications of TLE52052GPNT

• Operating Temperature Classification: Automotive
• Package Type: DSO
• Operating Supply Voltage (min): 5.3V
• Operating Supply Voltage (max): 40V
• Lead Free Status / RoHS Status: Compliant

1.7
Undervoltage lockout (UVLO):
When
All output transistors are switched off if the supply voltage
value
1.8
Various errors like short-circuit to +
result in turn-OFF of the output stages after a delay of 50 µs and setting of the error flag
EF to ground. Changing the inputs resets the error flag.
a. Output Shorted to Ground Detection
b. Output Shorted to +
c. Overload Detection
d. Overtemperature Protection
e. Open Load Detection
Data Sheet
If a high side transistor is switched on and its output is shorted to ground, the output
current is internally limited. After a delay of 50 µs all outputs will be switched-OFF and
the error flag is set.
If a low side transistor is switched on and its output is shorted to the supply voltage,
the output current is internally limited. After a delay of 50 µs all outputs will be
switched-OFF and the error flag is set.
An internal circuit detects if the current through the low side transistor exceeds the
trippoint
At a junction temperature higher than 150 °C the thermal shutdown turns-OFF, all four
output stages commonly and the error flag is set with a delay.
The output Q1 has a 10 kΩ pull-up resistor and the output Q2 has a 10 kΩ pull-down
resistor. If E1 and E2 are high, all output power stages are turned-OFF. In case of no
load between Q1 and Q2 the output voltage Q1 is
be detected by two comparators and an error flag will be set after a delay time of
50 µs. Changing the inputs resets the error flip flop.
V
V
S OFF.
S
Monitoring Functions
Protective Function
reaches the switch on voltage
I
SDL
. In this case all outputs are turned off after 50 µs and the error flag is set.
V
S
Detection
V
S
, ground or across the load are detected. All faults
V
S ON
6
the IC becomes active with a hysteresis.
V
S
and Q2 is ground. This state will
V
S
drops below the switch off
Rev. 1.1, 2007-07-31
TLE 5205-2
Overview