PPC405GP-3KE200C Applied Micro Circuits Corporation, PPC405GP-3KE200C Datasheet - Page 43

• Manufacturer Part Number: PPC405GP-3KE200C
• Manufacturer: Applied Micro Circuits Corporation

Specifications of PPC405GP-3KE200C

• Family Name: 405GP
• Device Core: PowerPC
• Device Core Size: 32b
• Frequency (max): 200MHz
• Instruction Set Architecture: RISC
• Supply Voltage 1 (typ): 2.5V
• Operating Supply Voltage (max): 2.7V
• Operating Supply Voltage (min): 2.3V
• Operating Temp Range: -40C to 85C
• Operating Temperature Classification: Industrial
• Mounting: Surface Mount
• Pin Count: 456
• Package Type: EBGA
• Lead Free Status / RoHS Status: Compliant

Revision 2.05 – August 19, 2008
Spread Spectrum Clocking
Care must be taken when using a spread spectrum clock generator (SSCG) with the PPC405GP. This controller
uses a PLL for clock generation inside the chip. The accuracy with which the PLL follows the SSCG is referred to
as tracking skew. The PLL bandwidth and phase angle determine how much tracking skew there is between the
SSCG and the PLL for a given frequency deviation and modulation frequency. When using an SSCG with the
PPC405GP the following conditions must be met:
Please refer to the application note Using a Spread Spectrum Clock Generator with the PowerPC 405GP for
additional details. This application note is available on the AMCC web site at http://www.amcc.com.
Notes:
1. The serial port baud rates are synchronous to the modulated clock. The serial port has a tolerance of
2. Operation of the PPC405GP PCI Bridge is unaffected by the use of a SSCG.
3. Ethernet operation is unaffected.
4. IIC operation is unaffected.
Caution: It is up to the system designer to ensure that any SSCG used with the PPC405GP meets the above
requirements and does not adversely affect other aspects of the system.
AMCC
• The frequency deviation must not violate the minimum clock cycle time. Therefore, when operating the
• The maximum frequency deviation cannot exceed −3%, and the modulation frequency cannot exceed 40kHz.
• Use the peripheral bus clock (PerClk) for logic that is synchronous to the peripheral bus since this clock tracks
• Use the SDRAM MemClkOut since it also tracks the modulation.
approximately 1.5% on baud rate before framing errors begin to occur. The 1.5% tolerance assumes that the
connected device is running at precise baud rates. If an external serial clock is used the baud rate is unaffected
by the modulation.
accomplished by strapping the PPC405GP for synchronous mode PCI and connecting the PCI bus clock to the
PPC405GP SysClk input. For 33.33 MHz signalling, the PCI specification has no limitation on the amount of
frequency deviation or modulation that may be applied to the PCI clock. Therefore, the PPC405GP SSCG
requirements stated above take precedence.
asynchronous mode, the PCI bus clock must be driven into the PPC405GP PCIClk input. In this configuration
the PCI controller supports the 66.66 MHz PCI clock specification which specifies a maximum frequency
deviation of -1% at a modulation of between 30 kHz and 33 kHz.
For PCI frequencies of 33.33 MHz and below the PCI controller supports synchronous mode operation. This is
At PCI frequencies above 33.33 MHz, the PCI controller must be operated in asynchronous mode. When in
PPC405GP with one or more internal clocks at their maximum supported frequency, the SSCG can only lower
the frequency.
In some cases, on-board PPC405GP peripherals impose more stringent requirements (see Note 1).
the modulation.
Data Sheet
405GP – Power PC 405GP Embedded Processor
43