804-1260 XANTREX TECHNOLOGY, 804-1260 Datasheet - Page 28

• Manufacturer Part Number: 804-1260
• Description: 60A-12V TRUECHARGE 2 SERIES BATTERIE CHARGER XANTREX
• Manufacturer: XANTREX TECHNOLOGY

Specifications of 804-1260

• Battery Charger Type: Switch Mode
• Battery Technologies Supported: Lead Acid
• Supply Voltage: 265VAC
• Charge Current Max: 60A

Installation
Tools and Materials
2–4
This guide for use by qualified installers only
To mount and connect the Truecharge™ 2 Battery
Charger you need the following tools:
•
•
•
•
•
•
You need the following materials:
•
•
•
•
•
•
•
10 mm socket wrench and extension for the DC terminals
and ground stud
Phillips screwdriver for removing and re-securing the AC
and DC wiring compartment covers
power drill/screwdriver
drill bit for pilot holes for mounting screws (if using #6
mounting screws, use 1/16 drill)
wire stripper
manufacturer's recommended crimp tool for any crimp
terminals that are being used
3 conductor AC input wiring
Use the information in “Installing AC Wiring” on
page 2–20 and your local electrical codes to determine
the correct wire and breaker or fuse.
AC cable strain relief (if the one included is not
compliant with your local electrical code requirements)
appropriately sized DC cables for each battery, with
suitable connectors at the battery end
Use the information in “DC Wiring” on page 2–8 and
your local electrical codes to determine the correct wire
and breaker or fuse.
appropriately sized DC chassis ground (earth) with
suitable connectors
ring terminals to fit 6 mm (1/4 in.) studs at the charger
end (Marine grade hardware is recommended).
DC fused disconnect or properly rated circuit breaker for
each battery bank
mounting screws, M3 or #6 marine grade, corrosion
resistant (4 pieces) (Length dependent on mounting
surface).
975-0402-01-01