804-1260 XANTREX TECHNOLOGY, 804-1260 Datasheet - Page 45

• Manufacturer Part Number: 804-1260
• Description: 60A-12V TRUECHARGE 2 SERIES BATTERIE CHARGER XANTREX
• Manufacturer: XANTREX TECHNOLOGY

Specifications of 804-1260

• Battery Charger Type: Switch Mode
• Battery Technologies Supported: Lead Acid
• Supply Voltage: 265VAC
• Charge Current Max: 60A

975-0402-01-01
AC supply wiring
This guide for use by qualified installers only
5. Carefully remove 50 – 75 mm (2 – 3 in.) of the outer
6. Extend the charger’s AC (L, N,
7. Feed the AC supply wiring through the wider end of
8. Slide the strain relief on the jacket of the wiring (not on
9. Connect the AC supply wires to the Truecharge™ 2
jacket from the AC supply wiring, being careful not to
cut or nick the insulation on the individual conductors.
from the AC wiring compartment of the charger.
strain relief and out the tapered end.
the individual conductors) approximately 25 mm (1 in.)
from the end of the jacket.
Battery Charger pigtail wires.
NOTE: Connect the line conductor to the AC line, the
neutral to the AC neutral, and the ground to the AC
ground. The wires are color coded as follows:
Conductor
Line
Neutral
Ground
Charger Pigtail
Color Code
Black
White
Green with yellow
stripe
Installing the Truecharge™ 2 Battery Charger
GND
Black (or brown)
) pigtail leads (wires)
AC Supply Wire
Color Code
White (or blue)
Green with yellow
stripe
tapered end
of strain relief
2–21