804-1260 XANTREX TECHNOLOGY, 804-1260 Datasheet - Page 34

• Manufacturer Part Number: 804-1260
• Description: 60A-12V TRUECHARGE 2 SERIES BATTERIE CHARGER XANTREX
• Manufacturer: XANTREX TECHNOLOGY

Specifications of 804-1260

• Battery Charger Type: Switch Mode
• Battery Technologies Supported: Lead Acid
• Supply Voltage: 265VAC
• Charge Current Max: 60A

Installation
Table 2-3 Fuse Sizes versus Wire Sizes Based on ABYC Regulations
AC Wiring
2–10
AWG
14
12
10
8
6
4
2
1
This guide for use by qualified installers only
The DC chassis ground (earth) wire should also be sized
correctly to provide proper protection. Refer to the local
electrical codes for your specific installation to determine the
correct gauge. The ABYC standards require this DC chassis
ground wire to be the same size as the largest DC + and –
conductors connected to the charger, or no more than one
wire size smaller.
WARNING: Risk of fire
Use only on circuits provided with 20A maximum branch circuit
protection in accordance with National Electrical Code, NFPA 70.
The AC wiring must be of sufficient size, and it must be
protected by the appropriate size and type of input breaker,
based on the jurisdiction and application. Some basic
examples are given below.
The AC input wiring for the Truecharge™ 2 Battery Charger
should be three-conductor cable, providing a line, neutral,
and ground conductor (or L, N,
Max. Fuse/Breaker
15 A
20 A
30 A
50 A
80 A
100 A
125 A
150 A
GND
) in an outer jacket, rated
975-0402-01-01