PIC18F6585-I/PT Microchip Technology Inc., PIC18F6585-I/PT Datasheet - Page 87

• Manufacturer Part Number: PIC18F6585-I/PT
• Description: 64 PIN, 48 KB FLASH, 3328 RAM, 52 I/O
• Manufacturer: Microchip Technology Inc.

Specifications of PIC18F6585-I/PT

• A/d Inputs: 12-Channel, 10-Bit
• Comparators: 2
• Cpu Speed: 10 MIPS
• Eeprom Memory: 1024 Bytes
• Input Output: 53
• Interface: CAN/I2C/SPI/USART
• Memory Type: Flash
• Number Of Bits: 8
• Package Type: 64-pin TQFP
• Programmable Memory: 48K Bytes
• Ram Size: 3.3K Bytes
• Speed: 40 MHz
• Timers: 1-8-bit, 3-16-bit
• Voltage, Range: 2-5.5 V
• Lead Free Status / Rohs Status: RoHS Compliant part Electrostatic Device

REGISTER 5-1:
 2004 Microchip Technology Inc.
bit 7
bit 6
bit 5
bit 4
bit 3
bit 2
bit 1
bit 0
EECON1 REGISTER (ADDRESS FA6h)
Legend:
R = Readable bit
W = Writable bit
‘1’ = Bit is set
bit 7
EEPGD: Flash Program or Data EEPROM Memory Select bit
1 = Access Flash program memory
0 = Access data EEPROM memory
CFGS: Flash Program/Data EEPROM or Configuration Select bit
1 = Access configuration registers
0 = Access Flash program or data EEPROM memory
Unimplemented: Read as ‘0’
FREE: Flash Row Erase Enable bit
1 = Erase the program memory row addressed by TBLPTR on the next WR command
0 = Perform write only
WRERR: Flash Program/Data EEPROM Error Flag bit
1 = A write operation is prematurely terminated
0 = The write operation completed
WREN: Flash Program/Data EEPROM Write Enable bit
1 = Allows write cycles
0 = Inhibits write to the EEPROM
WR: Write Control bit
1 = Initiates a data EEPROM erase/write cycle or a program memory erase cycle or write
0 = Write cycle to the EEPROM is complete
RD: Read Control bit
1 = Initiates an EEPROM read. (Read takes one cycle. RD is cleared in hardware. The RD bit
0 = Does not initiate an EEPROM read
EEPGD
R/W-x
Note:
(cleared by completion of erase operation)
(any Reset during self-timed programming in normal operation)
cycle. (The operation is self-timed and the bit is cleared by hardware once write is
complete. The WR bit can only be set (not cleared) in software.)
can only be set (not cleared) in software. RD bit cannot be set when EEPGD = 1.)
When a WRERR occurs, the EEPGD and CFGS bits are not cleared. This allows
tracing of the error condition.
R/W-x
CFGS
PIC18F6585/8585/6680/8680
U = Unimplemented bit, read as ‘0’
S = Settable bit
‘0’ = Bit is cleared
U-0
—
R/W-0
FREE
WRERR
R/W-x
WREN
R/W-0
- n = Value after erase
x = Bit is unknown
R/S-0
WR
DS30491C-page 85
R/S-0
RD
bit 0