SAB-C161PI-L25F CA Infineon Technologies, SAB-C161PI-L25F CA Datasheet - Page 42
![no-image](/images/manufacturer_photos/0/3/327/infineon_technologies_sml.jpg)
SAB-C161PI-L25F CA
Manufacturer Part Number
SAB-C161PI-L25F CA
Description
Microcontrollers (MCU) 16BIT SNGL CHIP 5V 25MHz ROM less
Manufacturer
Infineon Technologies
Datasheet
1.SAB-C161PI-L25F_CA.pdf
(82 pages)
Specifications of SAB-C161PI-L25F CA
Data Bus Width
16 bit
Program Memory Type
ROMLess
Data Ram Size
3 KB
Interface Type
ASC, I2C, SSC
Maximum Clock Frequency
25 MHz
Number Of Programmable I/os
76
Number Of Timers
5
Maximum Operating Temperature
+ 70 C
Mounting Style
SMD/SMT
Package / Case
TQFP-100
Minimum Operating Temperature
0 C
On-chip Adc
10 bit, 4 Channel
Packages
PG-TQFP-100
Max Clock Frequency
25.0 MHz
Sram (incl. Cache)
3.0 KByte
A / D Input Lines (incl. Fadc)
4
Program Memory
0.0 KByte
Lead Free Status / Rohs Status
Details
Other names
B161PIL25FCAXT
Data Sheet
DC Characteristics (Standard Supply Voltage Range) (continued)
(Operating Conditions apply)
Parameter
Power-down mode supply
current (5V) with RTC running
Power-down mode supply
current (5V) with RTC disabled
1) This specification is not valid for outputs which are switched to open drain mode. In this case the respective
2) These parameters describe the RSTIN pullup, which equals a resistance of ca. 50 to 250 K .
3) The maximum current may be drawn while the respective signal line remains inactive.
4) The minimum current must be drawn in order to drive the respective signal line active.
5) This specification is only valid during Reset, or during Hold- or Adapt-mode. During Hold mode Port 6 pins are
6) Not 100% tested, guaranteed by design characterization.
7) The supply current is a function of the operating frequency. This dependency is illustrated in the figure below.
8) This parameter is determined mainly by the current consumed by the oscillator. This current, however, is
9) This parameter is tested including leakage currents. All inputs (including pins configured as inputs) at 0 V to
output will float and the voltage results from the external circuitry.
only affected, if they are used (configured) for CS output and the open drain function is not enabled.
These parameters are tested at
at
The oscillator also contributes to the total supply current. The given values refer to the worst case, ie. I
For lower oscillator frequencies the respective supply current can be reduced accordingly.
influenced by the external oscillator circuitry (crystal, capacitors). The values given refer to a typical circuitry
and may change in case of a not optimized external oscillator circuitry.
0.1 V or at
IL
or
IH
.
DD
– 0.1 V to
DD
,
REF
DDmax
= 0 V, all outputs (including pins configured as outputs) disconnected.
and maximum CPU clock with all outputs disconnected and all inputs
Symbol
PDR5
PDO5
8)
40
–
–
min.
Limit Values
200 +
25*
50
max.
OSC
Unit Test Condition
A
A
OSC
DD
DD
=
=
in [MHz]
DDmax
DDmax
&3,
1999-07
PDRmax
9)
9)
.