ZFSM-201-KIT-1 CALIFORNIA EASTERN LABS, ZFSM-201-KIT-1 Datasheet - Page 9

• Manufacturer Part Number: ZFSM-201-KIT-1
• Manufacturer: CALIFORNIA EASTERN LABS

Specifications of ZFSM-201-KIT-1

• Lead Free Status / Rohs Status: Not Compliant

The four Timer I/O signals are available on the J3 connector.
This connector allows powering of the EVB directly (bypassing the regulator) through Pin 3 and
allows monitoring of the module’s VCC through Pin 4 (SENSE+)
The eight ADC input channels are available on the J5 connector.
The module contains an integrated PCB antenna and possesses the capacity to add an external
antenna to the module. A simple procedure for making this change (adding the connector,
changing the position of a capacitor) is included in APPENDIX 1: USING AN EXTERNAL
ANTENNA located at the end of this document.
Three 40-pin jumper connectors provide access to the I/O pins of the ZFSM-201-1 FreeStar Pro
module and as a result to most of the I/O pins of the Freescale MC13224V device.
Table 7 below shows the connections made by each jumper for each of the three connectors
J13, J14 and J15 as shown in Figure 2.
2.2.12 Timer I/O Connector [J3 4-pin]
2.2.13 Supply Voltage Connector [J4 4-pin]
2.2.14 ADC Input Channel Connector [J5 8-pin]
2.2.15 Add on Antenna
2.2.16 GPIO Jumpers [J13 40-pin, J14 40-pin, J15 40-pin]:
Rev B
Figure 2 – Pin numbering for the 40-pin Jumper Connectors (J13, J14 and J15)
ADC0
Pin 1
Table 6 – ADC Input Channel Connector pins
ADC1
Pin 2
(SENSE–)
Table 4 – Timer I/O Connector pins
Pin 1
GND
Document No. 0006-00-08-00-000
Table 5 – VCC Connector pins
TMR0
Pin 1
ADC2
Pin 3
Pin 2
GND
TMR1
Pin 2
ADC3
Pin 4
Pin 3
VCC
TMR2
ADC4
Pin 3
Pin 5
In
VCC Module
ADC5
TMR3
(SENSE+)
Pin 6
Pin 4
Pin 4
ADC6
Pin 7
ADC7
Pin 8
Page 9 of 42