SC16C654IA68,529 NXP Semiconductors, SC16C654IA68,529 Datasheet - Page 31

• Manufacturer Part Number: SC16C654IA68,529
• Description: IC UART QUAD W/FIFO 68-PLCC
• Manufacturer: NXP Semiconductors

Specifications of SC16C654IA68,529

• Number Of Channels: 4, QUART
• Fifo's: 64 Byte
• Voltage - Supply: 2.5V, 3.3V, 5V
• With Auto Flow Control: Yes
• With Irda Encoder/decoder: Yes
• With False Start Bit Detection: Yes
• With Modem Control: Yes
• With Cmos: Yes
• Mounting Type: Surface Mount
• Package / Case: 68-LCC (J-Lead)
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 568-3282-5; 935270051529; SC16C654IA68-S

Philips Semiconductors
9397 750 11617
Product data
7.10 Enhanced Feature Register (EFR)
7.9 Scratchpad Register (SPR)
Table 21:
[1]
The SC16C654/654D provides a temporary data register to store 8 bits of user
information.
Enhanced features are enabled or disabled using this register.
Bits 0 through 4 provide single or dual character software flow control selection.
When the Xon1 and Xon2 and/or Xoff1 and Xoff2 modes are selected, the double
8-bit words are concatenated into two sequential numbers.
Table 22:
Bit
1
0
Bit
7
6
Whenever any MSR bit 0-3 is set to logic 1, a Modem Status Interrupt will be generated.
Symbol
MSR[1]
MSR[0]
Symbol
EFR[7]
EFR[6]
Modem Status Register bits description
Enhanced Feature Register bits description
Quad UART with 64-byte FIFO and infrared (IrDA) encoder/decoder
Rev. 04 — 19 June 2003
Description
Description
Auto CTS. Automatic CTS Flow Control.
Auto RTS. Automatic RTS may be used for hardware flow control by
enabling EFR[6]. When Auto RTS is selected, an interrupt will be
generated when the receive FIFO is filled to the programmed trigger
level and RTS will go to a logic 1 at the next trigger level. RTS will return
to a logic 0 when data is unloaded below the next lower trigger level
(Programmed trigger level -1). The state of this register bit changes with
the status of the hardware flow control. RTS functions normally when
hardware flow control is disabled.
DSR
CTS
Logic 0 = No DSR change (normal default condition).
Logic 1 = The DSR input to the SC16C654/654D has changed state
since the last time it was read. A Modem Status Interrupt will be
generated.
Logic 0 = No CTS change (normal default condition).
Logic 1 = The CTS input to the SC16C654/654D has changed state
since the last time it was read. A Modem Status Interrupt will be
generated.
Logic 0 = Automatic CTS flow control is disabled (normal default
condition).
Logic 1 = Enable Automatic CTS flow control. Transmission will stop
when CTS goes to a logical 1. Transmission will resume when the CTS
pin returns to a logical 0.
Logic 0 = Automatic RTS flow control is disabled (normal default
condition).
Logic 1 = Enable Automatic RTS flow control.
[1]
[1]
…continued
SC16C654/654D
© Koninklijke Philips Electronics N.V. 2003. All rights reserved.
31 of 52