AT90PWM3B Atmel Corporation, AT90PWM3B Datasheet - Page 18

• Manufacturer Part Number: AT90PWM3B
• Manufacturer: Atmel Corporation

Specifications of AT90PWM3B

• Flash (kbytes): 8 Kbytes
• Pin Count: 32
• Max. Operating Frequency: 16 MHz
• Cpu: 8-bit AVR
• # Of Touch Channels: 8
• Hardware Qtouch Acquisition: No
• Max I/o Pins: 27
• Ext Interrupts: 4
• Usb Speed: No
• Usb Interface: No
• Spi: 1
• Uart: 1
• Graphic Lcd: No
• Video Decoder: No
• Camera Interface: No
• Adc Channels: 11
• Adc Resolution (bits): 10
• Adc Speed (ksps): 125
• Analog Comparators: 3
• Resistive Touch Screen: No
• Dac Channels: 1
• Dac Resolution (bits): 10
• Temp. Sensor: No
• Crypto Engine: No
• Sram (kbytes): 0.5
• Eeprom (bytes): 512
• Self Program Memory: YES
• Dram Memory: No
• Nand Interface: No
• Picopower: No
• Temp. Range (deg C): -40 to 105
• I/o Supply Class: 2.7 to 5.5
• Operating Voltage (vcc): 2.7 to 5.5
• Fpu: No
• Mpu / Mmu: no / no
• Timers: 5
• Output Compare Channels: 16
• Input Capture Channels: 1
• Pwm Channels: 12
• 32khz Rtc: No
• Calibrated Rc Oscillator: Yes

6. Memories
6.1
6.2
18
In-System Reprogrammable Flash Program Memory
SRAM Data Memory
AT90PWM2/3/2B/3B
This section describes the different memories in the AT90PWM2/2B/3/3B. The AVR architecture
has two main memory spaces, the Data Memory and the Program Memory space. In addition,
the AT90PWM2/2B/3/3B features an EEPROM Memory for data storage. All three memory
spaces are linear and regular.
The AT90PWM2/2B/3/3B contains 8K bytes On-chip In-System Reprogrammable Flash memory
for program storage. Since all AVR instructions are 16 or 32 bits wide, the Flash is organized as
4K x 16. For software security, the Flash Program memory space is divided into two sections,
Boot Program section and Application Program section.
The Flash memory has an endurance of at least 10,000 write/erase cycles. The
AT90PWM2/2B/3/3B Program Counter (PC) is 12 bits wide, thus addressing the 4K program
memory locations. The operation of Boot Program section and associated Boot Lock bits for
software protection are described in detail in
gramming” on page
on Flash programming in SPI or Parallel programming mode.
Constant tables can be allocated within the entire program memory address space (see the LPM
– Load Program Memory.
Timing diagrams for instruction fetch and execution are presented in
ing” on page
Figure 1. Program Memory Map
Figure 2
shows how the AT90PWM2/2B/3/3B SRAM Memory is organized.
14.
264.
“Memory Programming” on page 278
Application Flash Section
Boot Flash Section
Program Memory
“Boot Loader Support – Read-While-Write Self-Pro-
contains a detailed description
0x0000
0x0FFF
“Instruction Execution Tim-
4317J–AVR–08/10