SAM9G20 Atmel Corporation, SAM9G20 Datasheet - Page 29

• Manufacturer Part Number: SAM9G20
• Manufacturer: Atmel Corporation

Specifications of SAM9G20

• Flash (kbytes): 0 Kbytes
• Pin Count: 217
• Max. Operating Frequency: 400 MHz
• Cpu: ARM926
• Hardware Qtouch Acquisition: No
• Max I/o Pins: 96
• Ext Interrupts: 96
• Usb Transceiver: 3
• Usb Speed: Full Speed
• Usb Interface: Host, Device
• Spi: 2
• Twi (i2c): 1
• Uart: 7
• Ssc: 1
• Ethernet: 1
• Sd / Emmc: 1
• Graphic Lcd: No
• Video Decoder: No
• Camera Interface: Yes
• Adc Channels: 4
• Adc Resolution (bits): 10
• Adc Speed (ksps): 95
• Resistive Touch Screen: No
• Temp. Sensor: No
• Crypto Engine: No
• Sram (kbytes): 32
• Self Program Memory: NO
• External Bus Interface: 1
• Dram Memory: sdram
• Nand Interface: Yes
• Picopower: No
• Temp. Range (deg C): -40 to 85
• I/o Supply Class: 1.8/3.3
• Operating Voltage (vcc): 0.9 to 1.1
• Fpu: No
• Mpu / Mmu: No/Yes
• Timers: 6
• Output Compare Channels: 6
• Input Capture Channels: 6
• 32khz Rtc: Yes
• Calibrated Rc Oscillator: No

9.11
9.12
6384E–ATARM–05-Feb-10
Debug Unit
Chip Identification
• Three External Sources plus the Fast Interrupt signal
• 8-level Priority Controller
• Vectoring
• Protect Mode
• Fast Forcing
• Composed of two functions:
• Two-pin UART
• Debug Communication Channel Support
• Chip ID:0x019905A1
• JTAG ID: 0x05B2403F
• ARM926 TAP ID:0x0792603F
– Source 0 is reserved for the Fast Interrupt Input (FIQ)
– Source 1 is reserved for system peripherals
– Programmable Edge-triggered or Level-sensitive Internal Sources
– Programmable Positive/Negative Edge-triggered or High/Low Level-sensitive
– Drives the Normal Interrupt of the processor
– Handles priority of the interrupt sources 1 to 31
– Higher priority interrupts can be served during service of lower priority interrupt
– Optimizes Interrupt Service Routine Branch and Execution
– One 32-bit Vector Register per interrupt source
– Interrupt Vector Register reads the corresponding current Interrupt Vector
– Easy debugging by preventing automatic operations when protect models are
– Permits redirecting any normal interrupt source on the Fast Interrupt of the
– Two-pin UART
– Debug Communication Channel (DCC) support
– Implemented features are 100% compatible with the standard Atmel
– Independent receiver and transmitter with a common programmable Baud Rate
– Even, Odd, Mark or Space Parity Generation
– Parity, Framing and Overrun Error Detection
– Automatic Echo, Local Loopback and Remote Loopback Channel Modes
– Support for two PDC channels with connection to receiver and transmitter
– Offers visibility of and interrupt trigger from COMMRX and COMMTX signals from
enabled
processor
Generator
the ARM Processor’s ICE Interface
AT91SAM9G20
®
USART
29